Loading ...
Loading ...
Loading ...
INSTALLING THE ANTI-TIP STABILITY DEVICE
1)
The anti-tip bracket shipped with the range must be properly secured to
the rear wall as shown in the picture below.The height of the bracket
from the floor must be determined after the range legs have been
adjusted to the desired height and after the range has been levelled.
Measure the distance from the floor to the bottom of the anti-tip bracket
receptacle on the back of the appliance.
Position the two anti-tip brackets on the wall at the desired height
plus 1/8" (0.32 cm). The brackets must be placed at 2 - 5/16" (6.0 cm)
from each side of the range. The distance between the two bracket
is 25 - 1/4" (64.1 cm). Secure the brackets to the wall with appropriate
hardware. Slide the range against the wall until the brackets are fully
inserted into their receptacles on the back of the range.
Check to see that the Anti-Tip device is installed properly. Grasp the top
rear edge of the range and carefully attempt to tilt it forward. Verify that
the Anti-Tip device is engaged.
2) Or, use the anti-tip chain, and tighten up with fixed screw on the wall,
and when the wall not suitable for installation, the chain shall be fixed to
the cabinet structure.
INSTALL GUIDE
13
Loading ...
Loading ...
Loading ...