Loading ...
Loading ...
Loading ...
Push apart the latches, arrows 1, and re‐
move the bulb holder.
4. Remove the bulb holder from the opening.
5. Press the defective bulb gently into the
socket, turn clockwise and remove.
▷ Arrow 1: brake lights/tail lights
▷ Arrow 2: turn signal
▷ Arrow 3: reversing light
6. Proceed in the reverse order to insert the
new bulb and attach the bulb holder. Make
sure that the bulb holder engages in all fas‐
teners.
Central brake lamp and license plate
lamp
Follow the general instructions on lamps and
bulbs, refer to page 189.
The lamps feature LED technology. Contact
your service center in the event of a malfunc‐
tion.
Vehicles with a rear fog lamp
Follow the general instructions on Lamps and
bulbs, refer to page 189.
Bulbs: W16W
1. On vehicles with heat shield:
Loosen 3 screws, arrow.
2. Push the heat shield forward and the
bumper back in order to be able to reach
the fog lamp.
3. Turn the bulb socket counterclockwise and
remove.
The wire is long enough to guide the socket
down and through between any heat shield
that may be installed and the bumper.
4. Replace defective bulb.
5. To install the new bulb, proceed in reverse
order of removal.
Vehicle with two rear fog lamps
Follow the general instructions on Lamps and
bulbs, refer to page 189.
Bulbs: W16W
Left rear fog lamp:
1.
On vehicles with heat shield:
Seite 194
MOBILITY
Replacing components
194
Online Edition for Part no. 01 40 2 927 905 - II/14
Loading ...
Loading ...
Loading ...