Loading ...
Loading ...
Loading ...
Stowing the Mobility System
1. Disconnect the connection hose of the seal‐
ant bottle from the wheel.
2. Disconnect the connection hose from the
sealant bottle.
3. Wrap the empty sealant bottle and connec‐
tion hose in suitable material to avoid dirty‐
ing the cargo area.
4. Stow the Mobility System back in the vehi‐
cle.
Distributing the sealant
Immediately drive to ensure that the sealant is
evenly distributed in the tire.
Do not exceed a speed of .
Do not drop below if possible.
Correcting the tire inflation pressure
1.
Stop at a suitable location.
2. Screw the connection hose onto the tire
valve stem.
3. Attach the connection hose directly to the
compressor.
4. Insert the connector into a power socket in‐
side the vehicle.
5. Correct the tire inflation pressure to 2.5 bar.
▷ Increase pressure: with the ignition
turned on or the engine running, switch
on the compressor.
▷ To reduce the pressure: press the but‐
ton on the compressor.
Continuing the trip
Do not exceed the maximum permissible speed
of 50 mph/80 km/h.
Reinitialize the Flat Tire Monitor, refer to
page 97.
Reinitialize the Tire Pressure Monitor, refer to
page 94.
Replace the defective tire and the sealant bot‐
tle of the Mobility System as soon as possible.
Snow chains
Fine-link snow chains
Only certain types of fine-link snow chains have
been tested by the manufacturer of your vehi‐
cle, classified as road-safe and approved.
Information about the approved snow chains
are available from the service center.
Use
Use only in pairs on the front wheels, equipped
with the tires of the following size:
▷ 175/65 R 15.
Seite 178
MOBILITY
Wheels and tires
178
Online Edition for Part no. 01 40 2 927 905 - II/14
Loading ...
Loading ...
Loading ...