Loading ...
Loading ...
Loading ...
Reversing the doors.
37
Troubleshooting TipsInstallation Instructions
Customer Service
Operating InstructionsSafety Information
Rehang the Freezer Door on Dispenser Models
One person will need to hold the door as the other person routes the water
line through the conduit.
The conduit goes down into the fresh food door hinge. Insert the water line
into the conduit and push it through until it goes down to the bottom of the
refrigerator.
Lower the bottom socket of the freezer door onto the center hinge pin.
Be sure the washer is in place.
Tilt the door toward the cabinet, lifting the top hinge so the pin fits into the
socket on top of the door.
Tighten the top hinge screws after making sure the gap between the doors is
even all across the front.
Reconnect the 2 wire connectors.
Replace the 2 Torx screws to hold the top hinge to the cabinet. Replace the
hinge cover (on some models).
If the door swing is on the right side you will need to route the water line
across the front to the conduit on the bottom left side of the refrigerator.
Secure the water line in the clip behind the base channel. Feed the water line
through the conduit on the bottom until it comes out at the back of the
refrigerator near the water valve. Tighten the plastic nut firmly. Replace the
compressor compartment cover.
Replace the base grille and bottom hinge cover. Push the hinge cover on
completely.
Press the dispenser pad for at least 2 minutes. This will remove trapped air,
flush out the water line and fill the water system.
5
4
3
2
1
Conduit
Center Hinge Pin
Plastic Washer
Base Channel
Loading ...
Loading ...
Loading ...