Loading ...
Loading ...
Loading ...
Figure B
UNPACKING
Before installing your refrigerator, remove any tape or
temporary stickers. Do not remove any stickers that feature
warnings, the model serial number or the technical label of
the product located on the back of the refrigerator.
To remove adhesive tape residue, rub it well with your
fingers and a little liquid detergent. Clean with warm water
and let dry.
Do not use sharp instruments, rubbing alcohol, flammable
liquids or abrasive cleaning products to remove the
adhesive tape or glue. These products can damage the
surface of your refrigerator. For more information, see the
section on “Important Safety Instructions”.
The shelves come already installed in their factory position.
Remove the shelves and replace them according to your
spacing needs.
Moving Your Refrigerator:
Your refrigerator is extremely heavy. Make sure you
protect the floor when moving your refrigerator for
cleaning or servicing. Always pull your refrigerator
straight out when moving it. Do not shift from side to
side or “walk” the refrigerator when attempting to move
INSTALLATION
1. Avoid placing the unit near heat sources, direct sunlight,
or humidity.
2. To avoid vibration, the unit should be leveled. If needed,
adjust the leveling screws to compensate for an unlevel
floor. The front should be slightly taller than the rear to
ensure that the doors close properly. The leveling
screws can easily be turned by slightly tilting the front of
the refrigerator, turning the leveling screws clockwise
( ) to raise it and counter-clockwise ( ) to lower it.
3. Install the refrigerator in an area between 55 ° F (13 °C)
and 110° F (43 °C). If the surrounding temperature is
lower or higher than previously mentioned, it can
adversely affect the unit.
ONCE INSTALLED
1. Carefully clean your refrigerator and remove and
dust accumulated during shipping.
2. Install accessories such as the ice bin, door racks,
shelves, etc., in their proper places. These are already
packed to prevent any possible damage during shipping.
3. Leave your refrigerator on for 2 to 3 hours before
storing food inside. Verify that there is a flow of cold
air in the freezer compartment to ensure proper
cooling. Your refrigerator is now ready for use.
WARNING:
Take care when working with the hinges, base cover
and stops, etc. You may injure yourself.
DO not place your hands or any tools in the air vents,
the base cover or in the bottom of the refrigerator. This
may cause injury or electrical shock.
REFRIGERATOR INSTALLATION
WARNING
Excessive Weight Hazard
Use the assistance of two or more persons to move or
install the refrigerator. Not following these instructions
may cause injury to the back and other parts of the body.
WARNING
Keep all flammable materials and vapors (such as
gasoline) away from the refrigerator. Not following
these instructions may cause death, explosion or fire.
CAUTION: Avoid placing the unit near heat sources,
direct sunlight or humidity.
Explosion Hazard
Keep a Proper Distance from Adjacent
Please keep the refrigerator at an
Insufficient spacing can reduce the
increase electricity consumption.
(5.08 cm) 2”
INSTALLATION OF BASE GRILLE
Installing the Base Grille
Uninstalling or Replacing the Base Grille
1. Remove the 2 screws from the bottom front part of
your refrigerator (see Figure A).
2. Take off the cover.
1. Align the bottom cover and place in position. Insert
the 2 screws and twist in place (see Figure B).
10
refrigerator's freezing efficiency and
adequate distance from other objects.
Figure A
it as this can cause damage to the floor.
Objects
Loading ...
Loading ...
Loading ...