Loading ...
Loading ...
Loading ...
KNOWING YOUR SEWING MACHINE
13
1
Note
•When using the foot controller to operate
the sewing machine, connect the foot
controller before turning on the machine.
•When the foot controller is plugged in, the
start/stop button cannot be used to start
sewing (only for models equipped with the
start/stop button).
1
1 1 cm (3/8 inch)
CAUTION
• Make sure you follow the instructions carefully.
If you do not cut the thread completely, and
the bobbin is wound, when the thread runs
low it may tangle around the bobbin and cause
the needle to break.
7
(For models equipped with the sewing speed
controller)
Slide the sewing speed controller to the right
(to set the speed to fast).
1
Sewing speed
controller
8
Press the foot controller or press to start.
or
9
When the bobbin seems full and begins
spinning slowly, take your foot off the foot
controller or press
.
10
Cut the thread, slide the bobbin winder shaft
to the left and remove the bobbin.
11
(For models equipped with the sewing speed
controller)
Slide the sewing speed controller back to its
original position.
Mem
o
•When the sewing machine is started or the
handwheel is turned after winding the thread
around the bobbin, the machine will make a
clicking sound; this is not a malfunction.
•The needle bar does not move when you slide the
bobbin winding shaft to the right.
CAUTION
• Not winding the bobbin properly may cause
the thread tension to loosen, and may break
the needle.
1
2
1
Wound evenly
2
Wound poorly
■
For models equipped with the fast bobbin
winding system
1
Place the bobbin on the bobbin winder shaft
so that the spring on the shaft fits into the
notch in the bobbin. Then slide the shaft to
the right.
1
Notch
2
Spring
2
Follow steps 1 through 3 of the procedure
in “Winding the bobbin” to pass the thread
around the pre-tension disk (page 11).
3
Wind the free end of the thread clockwise
around the bobbin five or six times.
Loading ...
Loading ...
Loading ...