Loading ...
Loading ...
Loading ...
9
Water Pressure
A cold water supply with water pressure of between 30 and
water dispenser and ice maker. If you have questions about
■ If your refrigerator has a water dispenser: After installation is
complete, use the water dispenser to check the water pressure.
■
water. If 1 cup of water is dispensed in 8 seconds or less,
the water pressure to the refrigerator meets the minimum
requirement.
■ If it takes longer than 8 seconds to dispense 1 cup of
water, the water pressure to the refrigerator is lower than
recommended. See the “Troubleshooting” section for
suggestions.
Reverse Osmosis Water Supply
IMPORTANT: The pressure of the water supply coming out of
a reverse osmosis system going to the water inlet valve of the
refrigerator needs to be between 30 and 120 psi (207 and
cold water supply, the water pressure to the reverse osmosis system
If the water pressure to the reverse osmosis system is less than
■
■
after heavy usage.
■
water pressure when used in conjunction with a reverse osmosis
System” section in the User Instructions, User Guide, or Use &
Care Guide.
If you have questions about your water pressure, call a licensed,
Connect Water Supply
Read all directions before you begin.
IMPORTANT:
■ Plumbing shall be installed in accordance with the International
Plumbing Code and any local codes and ordinances.
■ The gray water tubing on the back of the refrigerator (which
connections from the household water line to the refrigerator
or water. Check for leaks.
■ Install tubing only in areas where temperatures will remain
above freezing.
TOOLS NEEDED:
Gather the required tools and parts before starting installation.
■
■
wrenches
■
Connect to Water Line
IMPORTANT: If you turn the refrigerator on before the water line
Style 1 (Recommended)
1. Unplug refrigerator or disconnect power.
2.
to clear line of water.
3.
NOTE:
recommended.
A
B
D
C
A. Bulb
B. Nut
4.
soft copper
■ Ensure that you have the proper length needed for the job.
Be sure both ends of the copper tubing are cut square.
■ Slip compression sleeve and compression nut onto copper
tubing as shown. Insert end of tubing into outlet end
squarely as far as it will go. Screw compression nut onto
outlet end with adjustable wrench. Do not overtighten.
B CA
A. Compression sleeve
B. Compression nut
C. Copper tubing
5. Place the free end of the tubing into a container or sink, and
NOTE:
connection to the inlet of the water valve to avoid possible
water valve malfunction.
6. Bend the copper tubing to meet the water line inlet, which is
located on the back of the refrigerator cabinet as shown. Leave
a coil of copper tubing to allow the refrigerator to be pulled
out of the cabinet or away from the wall for service.
Style 2
1. Unplug refrigerator or disconnect power.
2.
to clear line of water.
3.
1
/
pipe near the refrigerator.
Loading ...
Loading ...
Loading ...