Loading ...
Loading ...
Loading ...
9
Insert coins until “SELECT CYCLE” ashes in 1.
display. When a card reader is used a debit card is required
rather than coins. In Enhanced Debit mode, the card
balance will also display when a debit card is inserted into
th e reader.
Door must be closed before cycle selection is made.2.
Press fabric setting keypad for the wash cycle desired. After 3.
the cycle is started, the time will display and count down.
When a cycle is interrupted by opening the door, 4.
“RESELECT CYCLE” will ash in the display. To restart the
washer, close door, and press any key.
General User Information
“- - - -” INOPERATIVE STATE – These lines on the display
indicate the appliance is inoperative. Enter Washer Diagnostic
Mode to view diagnostic code.
“0 MINUTES” SHOWING IN DISPLAY – This condition indicates
the appliance cannot be operated. Coins dropped or debit
inputs during this condition will be stored in escrow, but cannot
be used until normal operation is restored by opening and
closing the door. If a door switch fails, it must be replaced before
normal operation can be restored.
COLD START (Initial rst use) – Appliance is programmed at the
factory as follows:
Washer 14-minute wash period
3 rinses (extra rinse not enabled)
$1.75 wash price
WARM START (after power failure) – A few seconds after power
is restored, if a cycle was in progress at the time of the power
failure, “RESELECT CYCLE” will ash in the display, indicating
the need for a key press to restart washer.
DOOR LOCK – The door will be locked when the cycle
starts. The door will remain locked until the end of a cycle or
approximately 2 minutes after a power interruption.
PRICING – After the door is opened following the completion of
a cycle, the display indicates the cycle price (unless set for free
operation). As coins are dropped or debit inputs arrive,
the display will change to lead the user through the initiation
of a cycle.
FREE CYCLES – This is established by setting the cycle price to
zero. When this happens, “SELECT CYCLE” will appear rather
than a cycle price.
DEBIT CARD READY – This appliance is debit card “cable”
ready. It will accept a variety of debit card systems, but does not
come with a debit card reader or a card reader cable. Refer to
the debit card reader manufacturer for proper washer setup. In
models converted to a Generation 1 debit card system a debit
pulse represents the equivalent of one coin.
DISPLAY – After the washer has been installed and plugged in,
the display will show “0 MINUTES.” Once the washer has been
plugged in and the washer door opened and closed, the display
will show the price. In washers set for free cycles, the display
will ash “SELECT CYCLE.”
Control Setup Procedures
IMPORTANT: Read all instructions before operating.
All Models: Insert service door key, turn, and lift to remove
access door.
The washer is now in the setup mode.
The temperature keypads and the digital display are used to set
up the controls.
The display can contain 4 numbers and/or letters and a decimal
point. These are used to indicate the setup codes and related
code values available for use in programming the appliance.
SETUP INSTRUCTIONS
Loading ...
Loading ...
Loading ...