Loading ...
Loading ...
Loading ...
6
INSTALLATION INSTRUCTIONS
Remove Transport System
WARNING
Excessive Weight Hazard
Use two or more people to move and install washer.
Failure to do so can result in back or other injury.
IMPORTANT: Position the washer so that the rear of the washer
is within approximately 3 ft (90 cm) of its nal location.
There are 4 blue spacers secured by bolts in the rear panel
of the washer that support the suspension system during
transportation. These spacers also retain the power cord inside
the washer until the bolts are removed.
Keep the washer in the upright position while removing the 1.
blue spacers.
Using a 2.
1
⁄2" wrench, loosen each of the bolts.
Once the bolt is loose, move it to the center of the hole and 3.
completely pull out the bolt, including the plastic spacer
covering the bolt.
Once all 4 bolts are removed, discard the bolts and spacers. 4.
Then push the plug back into the back of the washer and
pull the power cord through the left opening of the rear panel
and close the hole with the attached cap.
Close the bolt holes with the 4 transport bolt hole plugs.5.
NOTE: If the washer is to be transported at a later date, call
your distributor. To avoid suspension and structural damage,
your washer must be properly set up for relocation by a trained
professional.
Connect the Inlet Hoses
Insert new at washers (supplied) into each end of the inlet
hoses. Firmly seat the washers in the couplings.
A B
A. Coupling
B. Washer
Connect the inlet hoses to the water faucets
Make sure the washer drum is empty.
Attach a hose to the hot water faucet. Screw on coupling 1.
by hand until it is seated on the at rubber washer.
Attach a hose to the cold water faucet. Screw on coupling 2.
by hand until it is seated on the at rubber washer.
Using pliers, tighten the couplings with an additional 3.
two-thirds turn.
NOTE: Do not overtighten, use tape, or sealants on the valve.
Damage to the valves can result.
Loading ...
Loading ...
Loading ...