Loading ...
Loading ...
Loading ...
Menu Settings
124
Serial communication
> [System settings] > [Serial communication]
You can check setting values for the service port (CONTROL) used for serial
communication.
Power management mode
> [System settings] > [Power management mode]
You can specify to turn off the lamp or projector automatically after a certain period
if the projector and remote control are not used and there is no input signal.
Power management duration
> [System settings] > [Power management duration]
Specify how long before the lamp is turned off or the projector enters standby,
depending on the [Power management mode] setting.
Option Function
Baud rate Modulation rate, in bits per second.
Data bits Number of bits of data.
Parity Number of parity bits.
Stop bit
Specify the length of the mark representing the end of data bits.
Option Function
Disabled Disable power management mode.
Lamp off Only turns the lamp off.
Standby Turns the projector off and puts it in standby.
• After the lamp is turned off, projection resumes when:
- the same input signal is restored.
- the remote control or projector is operated.
- the power is turned on.
• After the projector enters standby, restoring projection requires the same steps as when
turning the projector on normally.
• When [Disabled] is selected, [Direct power on] (P125) is not available.
Option Function
5 min. - 60 min.
After 30 seconds without an input signal when the projector is idle,
the projector starts displaying a countdown of the selected time.
• If conditions that would start countdown are met while you are blanking projection,
blanking is canceled.
• Once countdown begins, audio output stops.
Option Function
1 Sets the stop bit length to 1.
2 Sets the stop bit length to 2.
Loading ...
Loading ...
Loading ...