Loading ...
Loading ...
Loading ...
11
PRACTICAL INFORMATION
CHANGING A FRONT OR REAR
WIPER BLADE
Procedure for replacing a worn wiper
blade with a new one without the use
of tools.
Before removing a front wiper blade
Within one minute after switching off
the ignition, operate the wiper stalk
to position the wiper blades in the
vertical position.
This position must be used in order to
avoid damaging the wiper blade and the
bonnet.
Removal
Raise the corresponding wiper arm.
Unclip the wiper blade and remove it.
Fitting
At the front, check the size of the wi-
per blade as the shorter blade is fi tted
to the passenger side of the vehicle.
Put the corresponding new wiper
blade in place and clip it.
Fold down the wiper arm carefully.
After fitting a front wiper blade
Switch on the ignition.
Operate the wiper stalk again to
park the wiper blades.
TOWING THE VEHICLE
Procedure for having your vehicle towed
or for towing another vehicle using a re-
movable towing eye.
Access to the tools
The towing eye is installed in the boot
under the fl oor.
To gain access to it:
open the boot,
raise the fl oor,
remove the polystyrene storage box,
remove the towing eye from the
holder.
General
recommendations
Observe the legislation in force
in your country.
Ensure that the weight of the
towing vehicle is higher than
that of the towed vehicle.
The driver must stay at the
wheel of the towed vehicle.
Driving on motorways and fast
roads is prohibited when towing.
When towing a vehicle with all
four wheels on the ground, al-
ways use an approved towing
bar; rope and straps are pro-
hibited.
When towing a vehicle with the
engine off, there is no longer
any power assistance for bra-
king or steering.
In the following cases, you
must always call on a profes-
sional recovery service:
- vehicle broken down on a
motorway or fast road,
- when it is not possible to
put the gearbox into neu-
tral, unlock the steering, or
release the parking brake,
- towing with only two wheels
on the ground,
- where there is no approved
towing bar available...
Loading ...
Loading ...
Loading ...