Loading ...
Loading ...
Loading ...
12 13
OPERATING YOUR BREVILLE PRODUCT
PRE-PROGRAMMED
SHOT VOLUME – 1 CUP
Press the 1 CUP once. A preset volume of
approximately 30mls will be extracted. The
machine will automatically stop once the
preset volume has been extracted.
NOTE
The amount of espresso extracted in
the cup will vary depending on your
grind size and dose amount.
PRE-PROGRAMMED
SHOT VOLUME – 2 CUP
Press the 2 CUP button once. A preset
volume of approx. 60mls will be extracted.
The machine will automatically stop once
the preset volume has been extracted.
NOTE
Pressing the 1 CUP or 2 CUP buttons
during a programmed espresso will
immediately stop the extraction.
PROGRAMMING SINGLE ESPRESSO
1. To begin programming, press
the PROGRAM button once. The
machine will beep once and the
program button will begin to flash.
This indicates the machine is in
programming mode.
2. Press 1 CUP button to start espresso
extraction. Press 1 CUP again once
desired volume of espresso has been
extracted. The machine will beep
twice to indicate the new 1 CUP
volume has been set.
PROGRAMMING DOUBLE ESPRESSO
1. To begin programming, press the
PROGRAM button once. The machine
will beep once and the program button
will begin to flash. This indicates the
machine is in programming mode.
2. Press 2 CUP button to start espresso
extraction. Press 2 CUP again once
desired volume of espresso has been
extracted. The machine will beep
twice to indicate the new 2 CUP
volume has been set.
OPERATING YOUR BREVILLE PRODUCT
FILLING THE WATER TANK
• Ensure the water filter is securely fitted
inside the tank.
• Fill the water tank with cold tap water
to the maximum mark on the side of the
tank and slide the water tank back into
position at the back of the machine.
• Plug the power cord into power outlet
and switch On at power point.
• Press the POWER button to On. The
POWER button surround will flash
while the machine is heating. When the
correct temperature has been reached,
all the button surrounds on the control
panel will illuminate.
NOTE
Check the water level before use and
replace the water daily. The water
tank should be filled with fresh, cold
tap water before each use.
Do not use mineral or distilled water
or any other liquid.
TAMPING THE GROUND COFFEE
• Once the grind function has been
completed, carefully withdraw the
portafilter from the grinding cradle,
being careful not to spill any ground
coffee, tap down to collapse and using
the integrated tamper, tamp down firmly
(approx. 15–20 kg of pressure).
TRIMMING THE DOSE
The Razor™ precision dose trimming tool
allows you to trim the puck to the right level
for a consistent extraction.
the Razor
™
Precision dose trimming tool
Insert the Razor™ into the coffee basket
until the shoulders of the tool rest on the
rim of the filter basket. The blade of the
dosing tool should penetrate the surface
of the tamped coffee.
Rotate the Razor™ dosing tool back and forth
while holding the portafilter on an angle over
the knock box to trim off excess coffee.
Your coffee filter basket is now dosed with
the correct amount of coffee.
NOTE
When using a finer espresso grind for
the Single Wall Filter basket, you will
need to increase the grind amount to
ensure the filter is correctly dosed.
Loading ...
Loading ...
Loading ...