Loading ...
Loading ...
Loading ...
26 27
PAge heAder..... PAge heAder.....
CARE & CLEANING
DECALCIFYING
After regular use, hard water can cause
mineral build up in and on many of the
inner functioning components, reducing
the brewing flow, power of the machine,
and affecting the quality of coffee.
We advise decalcifying the machine on a
regular basis (every 2-3 months) using a
mixture of white vinegar and water.
Follow the instructions provided, or use
the following as a guide:
SOLUTION FOR DECALCIFYING
Diluted Solution (for softer water)
• 1 part white vinegar
• 2 parts cold tap water
Concentrated Solution (for harder water)
• 1 part white vinegar
• 1 part cold tap water
WARNING
Do not immerse power cord, power
plug or appliance in water or any other
liquid. The water tank should never be
removed or completely emptied during
decalcifying.
DECALCIFYING THE MACHINE
• Remove the portafilter. Pour the mixture
of white vinegar and water into the
water tank.
• Plug the machine into the power outlet
and switch On.
• Press the POWER button to the
On position.
• Place a large container under the
group head and steam wand.
• When the brewing temperature has
been reached all the button surrounds
on the control panel will illuminate.
Press and hold the 1 CUP or 2 CUP
button to commence manual pour.
Release the button once half the mixture
of white vinegar and water has run
through the group head.
• Set the STEAM/HOT WATER dial to
the STEAM position and allow steam
to run through the Steam Wand for
approximately 2 minutes. Return the
steam dial back to the STANDBY position.
• After decalcifying, remove the water
tank and rinse thoroughly then refill
with fresh cold water. To rinse the
machine, repeat previous steps.
CARE & CLEANING
CLEANING THE STEAM WAND
• The steam wand should always be
cleaned after texturing milk.
• Wipe the steam wand with a damp cloth,
and then with the steam wand directed
back into the drip tray, briefly set the
steam dial to the STEAM position. This
will clear any remaining milk from
inside the steam wand.
• Ensure the steam dial is in the STANDBY
position. Press the POWER button to Off
and allow the machine to cool.
• If the steam wand remains blocked,
use the pin on the cleaning tool to clear
the opening.
• If the steam wand continues to be
blocked, the tip of the steam wand can
be removed by using the spanner in the
middle of the cleaning tool.
• Unscrew the tip with the cleaning tool.
• Soak the tip in hot water before using
the pin on the cleaning tool to unblock.
Replace the tip back onto the steam
wand and secure with the cleaning tool.
Wipe steam wand after
each use
Clean hole with pin Remove tip Soak tip overnight then
re-attach
Run steam to clear milk
from wand after texturing
1 2 3 4 5
Loading ...
Loading ...
Loading ...