Loading ...
Loading ...
Loading ...
49-60769 25
INSTALLATION INSTRUCTIONS
Installation Instructions
INSTALLING THE WATER LINE (Continued)
9
CONNECT THE TUBING TO THE
REFRIGERATOR (Continued)
Place the compression nut and ferrule (sleeve)
onto the end of the tubing as shown. On
SmartConnect™RefrigeratorTubingkit,thenuts
are already assembled to the tubing.
Inserttheendofthetubingintothewatervalve
connection as far as possible. While holding the
tubing, tighten the fitting.
ForplastictubingfromaSmartConnect
Refrigerator Tubing kit, insert the molded end of
the tubing into the refrigerator connection and
tighten compression nut until it is hand tight,
then tighten one additional turn with a wrench.
Overtightening may cause leaks.
Fastenthetubingintotheclampprovidedto
hold it in a vertical position. You may need to pry
open the clamp.
Tubing
Clamp
1/4"
Compression
Nut
SmartConnect
™
Tubing
Refrigerator
Connection
1/4"Tubing
Ferrule
(sleeve)
10
TURN THE WATER ON AT THE
SHUTOFF VALVE
Tighten any connections
that leak.
Reattach the compressor
compartment access
cover.
12
PLUG IN THE REFRIGERATOR
Arrange the coil of tubing
so that it does not vibrate
against the back of the
refrigerator or against the
wall. Push the refrigerator
back to the wall.
13
START THE ICEMAKER
Set the icemaker power
switch to the ON
position. The icemaker
will not begin to operate
until it reaches its
operating temperature
of15°F(–9°C)or
below.Itwillthenbegin
operation automatically
if the icemaker power
switch is in the ON position.
11
REINSTALL THE COVER
Reinstall the compressor compartment access
cover. This requires using the screws you removed
previously to
reattach the cover
to the back of
the refrigerator
case. This must
be reinstalled for
your refrigerator to
function properly.
The water line
should come out
at the water relief
slot at the right
side, above the
power line.
Water
Line
Power
Line
Loading ...
Loading ...
Loading ...