Loading ...
Loading ...
Loading ...
Fault, what to do? aus
37
Plastic parts discoloured. Rinsing temperature too low. Select programme with higher rinsing
temperature.
Utensils precleaned too intensely;
sensors therefore decide on
weak programme sequence.
Stubborn soiling cannot be
completely removed.
Do not prerinse utensils.Remove only
large food remnants.
Removable streaks on
glasses, glasses with
metallic appearance and
cutlery.
Too much rinse aid. Set rinse aid amount to lower setting
setting.
No rinse aid added or setting too
low.
Add rinse aid and check dosage
(recommended Level 4–5).
Detergent residue in the final
rinse. Detergent dispenser cover
blocked by utensils (cover does
not open fully).
Detergent dispenser cover must not be
obstructed by utensils.
Do not place utensils or fragrance
dispenser in the tablet collecting tray.
Utensils precleaned too intensely;
sensors therefore decide on
weak programme sequence.
Stubborn soiling cannot be
completely removed.
Do not prerinse utensils.Remove only
large food remnants.
Initial or existing,
irreversible clouding of
glass.
Glasses not dishwasher-proof,
only suitable for dishwasher.
Use dishwasher-proof glasses.
Avoid long steam phase (standing time
after rinse cycle ends).
Use rinse cycle at lower temperature.
Use detergent with glass protection
component.
Rust spots on the cutlery. Cutlery is not sufficiently
rust-resistant.Knife blades are
frequently more severely
affected.
Use rust-resistant cutlery.
Cutlery will also rust if rusting
parts are rinsed at the same time
(pan handles, damaged utensil
baskets, etc.).
Do not wash rusting parts.
Appliance cannot be
switched on or operated.
Malfunction. Disconnect appliance from the power
supply; pull out the mains plug or switch
off the fuse. Wait at least 5 seconds, then
connect the appliance to the power
supply.
Fault Reason Solution
Loading ...
Loading ...
Loading ...