Loading ...
Loading ...
Loading ...
Fault, what to do? aus
33
Fault code “:ƒˆ is lit. Mains voltage too low. No appliance fault, have the mains voltage
and electrical installation checked.
A different fault code is
indicated on the digital
display.
(“:‹‚ to “:„‹)
A technical fault has probably
occurred.
Switch off the appliance with the ON/OFF
switch (.After a short time, restart the
appliance.
If the problem recurs, turn off the tap and
pull out the mains plug.
Call customer service and mention the
fault code.
p or • appears on the
digital display h. *
Not a fault! See TurboSpeed 20 min. in the chapter
“Overview of programmes”. *
Refill indicator for rinse aid
` is lit.
No rinse aid. Refill rinse aid.
Refill indicator for rinse aid
` is not lit.
Refill indicator switched off. Activation/Deactivation. ~ Page 13
There is still enough special rinse
aid available.
Check the filling level, refill indicator.
Water is left in the
appliance at the end of the
programme.
Filter system or area under the
filters 1J is blocked.
Clean filters and area underneath (see
“Waste water pump”).
Programme not finished yet Wait until programme ends or reset (see
“Terminating the programme”).
Fault Reason Solution
Loading ...
Loading ...
Loading ...