Loading ...
Loading ...
Loading ...
aus Fault, what to do?
32
Fault table
Fault Reason Solution
“Check water supply”
display X lights up.
Supply hose kinked. Install supply hose without kinks.
Tap turned off. Turn on the tap.
Tap jammed or calcified. Turn on the tap.
Flow rate must be at least 10 l/min. when
water supply is open.
Filter in the water supply blocked. Switch off the appliance and pull out the
mains plug. Turn off the tap. Unscrew
water connection.
Clean filter in the supply hose. Screw
water connection on again. Check for
leaks. Reconnect power supply. Switch on
the appliance.
Fault code “:‹ˆ is lit. Intake opening (on right inside of
appliance) covered by utensils.
Arrange utensils so that the intake
opening is not obstructed.
Fault code “:‚ƒ is lit. Heating element soiled. Clean appliance with dishwasher cleaning
agent.
Fault code “:‚… is lit. Water protection active. Turn off tap.
Call customer service and quote the fault
code.
Fault code “:‚† is lit.
Fault code “:‚‡ is lit. Constant water supply.
Fault code “:ƒƒ is lit. Filters 1J are soiled or
blocked.
Clean filters.~ "Filters" on page 29
Fault code “:ƒ… is lit. Wastewater hose kinked or
blocked.
Install hose without kinks, remove any
residue.
Siphon connection still sealed. Check connection to siphon and open if
required.
Cover on the wastewater pump
loose.
Lock cover correctly.~ "Waste water
pump" on page 31
Fault code “:ƒ† is lit. Wastewater pump blocked or
cover on the wastewater pump is
not locked in position.
Clean pump and lock cover correctly.
~ "Waste water pump" on page 31
Loading ...
Loading ...
Loading ...