Loading ...
Loading ...
Loading ...
FILTERS AND ACCESSORIES
18
RESET the water lter status tracking feature. After you
replace the disposable lter with a new lter, closing the lter
compartment door will automatically reset the lter status
tracking feature. See “Using the Control(s)” section.
NOTE: “REPLACE FILTER” will remain illuminated if a lter is
not installed or is installed incorrectly.
Replace the Water Filter
To purchase a replacement water lter, see “Accessories” in the
User Guide, Use and Care Guide or User Instructions.
Replace the disposable water lter when indicated on the water
lter status display or at least every 6 months. If water ow to
your dispenser or ice maker decreases noticeably, change the
water lter sooner.
1. Locate the water lter compartment in the right-hand side
of the refrigerator ceiling. Push up to release and lower the
compartment door.
2. Turn the water lter counterclockwise (to the left), and pull it
straight out of the compartment.
NOTE: There may be some water in the lter. Some spilling
may occur. Use a towel to wipe up any spills.
3. Install the replacement water lter by following steps 2
through 7 in the “Install the Water Filter” section.
Install Air Filter (on some models)
An air lter is 15 times more powerful than baking soda at
reducing common food odors inside the refrigerator.
On some models, your refrigerator’s accessory packet includes
an air lter, which must be installed prior to use.
Installing the Air Filter
Install the air lter behind the vented door, located on the rear
wall near the top of the refrigerator compartment.
1. Remove the air lter from its packaging.
2. Lift open the vented door.
3. Snap the lter into place.
Installing the Filter Status Indicator
The lter comes with a status indicator, which should be
activated and installed at the same time the air lter is installed.
1. Place the indicator face-down on a rm, at surface.
2. Apply pressure to the bubble on the back of the indicator until
the bubble pops to activate the indicator.
3. Lift open the vented air lter door. On some models, there are
notches behind the door.
Models with notches:
With the indicator screen facing outward, slide the
indicator down into the notches.
NOTE: The indicator will not easily slide into the notches if
the bubble has not been popped.
Close the air lter door, and check that the indicator is
visible through the window in the door.
A
A. Air lter
B
A
C
A. Status indicator window
B. Air lter status indicator
C. Notches
Loading ...
Loading ...
Loading ...