Loading ...
Loading ...
Loading ...
45
WHEN ALL HOOKUPS ARE COMPLETED:
MAKE SURE ALL CONTROLS ARE LEFT IN
THE OFF POSITION.
MAKE SURE THE FLOW OF COMBUSTION
AND VENTILATION AIR TO THE RANGE IS
UNOBSTRUCTED.
CONVERTING TO LP GAS
(or converting back to natural gas from LP)
This range leaves the factory set for use with
natural gas. If you want to convert to LP gas, the
conversion must be performed by a qualified LP
gas installer.
The conversion instructions and LP orifices
can be found attached to the range next to
the pressure regulator.
Keep these instructions and the orifices in case
you want to convert back to natural gas.
1. Mark the wall where the RIGHT EDGE of the
range is to be located. Be sure to allow for the
countertop overhang if you intend to install the
range next to cabinets.
2. Locate the outside edge of the device 2
1
⁄8″
toward the center of the range from the marked
edge of the range.
3. Using the device as a template, mark the
position of the hole for the screw.
4. For wood construction, drill a pilot hole at an
angle of 20 degrees from the horizontal. A nail
or awl may be used if a drill is not available.
Mount the Anti-Tip device with the screw
provided.
For cement or concrete construction, you
will need a 1/4″ x 1
1
⁄
2
″ lag bolt and a 1/2″ O.D.
sleeve anchor, which are not provided. Drill
the recommended size hole for the hardware.
Install the sleeve anchor into the drilled hole
and then install the lag bolt through the device.
The bolts must be properly tightened as
recommended for the hardware.
5. Slide the range against the wall, and check
for proper installation by grasping the front
edge of the cooktop and carefully attempting
to tilt the range forward.
Marked edge
of range
Approx.
Slotted
head
screw
Anti-Tip
device
Wallplate
Wood screw
Wallplate
Anti-Tip
device
Back of
range
Wallboard
20°
2
1
⁄8″
Loading ...
Loading ...
Loading ...