Loading ...
Loading ...
Loading ...
33
Care and Cleaning
Oven Light Replacement (on some models)
CAUTION: Before replacing your oven light bulb,
disconnect the electrical power to the range at the
main fuse or circuit breaker panel. Be sure to let
the light cover and bulb cool completely.
The oven light bulb is covered with a removable
glass cover that is held in place with a bail-shaped
wire. Remove the oven door, if desired, to reach
cover easily.
To remove:
1. Hold a hand under the
cover so it doesn’t fall
when released. With
fingers of the same
hand, firmly push back
the wire cover holder.
Lift off the cover.
DO NOT REMOVE ANY SCREWS TO
REMOVE COVER.
2. Do not touch hot bulb with a wet cloth. Replace
bulb with a 40-watt household appliance bulb.
To replace cover:
1. Place it into the groove of the light receptacle.
Pull the wire forward to the center of the cover
until it snaps into place. When in place, the wire
holds the cover firmly. Be certain the wire is in
the depression in the center of the cover.
2. Connect electrical power to the range.
Wire cover holder
Control Panel and Knobs
It’s a good idea to wipe the control panel after each
use of the oven. Clean with mild soap and water or
vinegar and water, rinse with clean water and polish
dry with a soft cloth.
Do not use abrasive cleansers, strong liquid cleaners,
plastic scouring pads or oven cleaners on the control
panel—they will damage the finish. A 50/50 solution
of vinegar and hot water works well.
The control knobs may be
removed for easier cleaning.
To remove a knob, pull it
straight off the stem. If knob
is difficult to remove, place
a towel or dishcloth between
the knob and control panel and pull gently.
Wash the knobs in soap and water or a vinegar and
hot water solution.
Metal parts can be cleaned with soap and water.
Do not use steel wool, abrasives, ammonia, acids or
commercial oven cleaners. Dry with a soft cloth.
Removable Storage Drawer (on some models)
The storage drawer is a good place to store cookware
and bakeware. Do not store plastics and flammable
material in the drawer.
The storage drawer may be removed for cleaning
under the range. Clean the storage drawer with a
damp cloth or sponge. Never use harsh abrasives
or scouring pads.
To remove storage drawer:
1. Pull drawer straight
out until it stops.
2. Tilt the front of the
drawer up and free
of the range.
To replace storage drawer:
1. Set the stops on the back of the drawer over the
stops in the range.
2. Slide drawer evenly and straight back, so that the
rails in the range are engaged.
(continued next page)
GEAppliances.com
Loading ...
Loading ...
Loading ...