Loading ...
Loading ...
Loading ...
44
INSTALLATION INSTRUCTIONS
INSTALLING THE ANTI-TIP DEVICE
WARNING:
• Range MUST be secured with an
approved Anti-Tip device.
• Unless properly installed, the range could
be tipped by you or a child standing,
sitting or leaning on an open door.
• After installing the Anti-Tip device, verify
that it is in place by carefully attempting
to tilt the range forward.
• This range has been designed to meet all
recognized industry tip standards for all
normal conditions.
• The use of this device does not preclude
tipping of the range when not properly
installed.
• If the Anti-Tip device supplied with the
range does not fit this application, use the
universal Anti-Tip device WB02X7909.
9
LEVELING THE RANGE
1. Install the oven
shelves in the oven
and position the range
where it will be installed.
2. Check for levelness
by placing a spirit level
or a cup, partially filled
with water, on one of the
oven shelves. If using a
spirit level, take two
readings—with the level
placed diagonally first in
one direction and then
the other.
3. Remove the storage
drawer or kick panel.
On some models, the
front leveling legs can
be accessed from the
bottom and the rear
legs from the top.
4. Use an open-end or
adjustable wrench to
adjust the leveling legs
until the range is level.
5. After the range is level, slide the range away
from the wall so that the Anti-Tip device can be
installed.
8
Raise
range
Lower
range
Leg
leveler
Lower
range
Raise
range
(on some models)
(on some models)
ADJUST BROIL AND OVEN BURNER AIR
ADJUSTMENT SHUTTERS IF NECESSARY
(continued)
To determine if the bottom burner flames are
burning properly, remove the oven bottom.
Flames should have approximately 1″ blue
cones and, if range is supplied with natural gas,
should burn with no yellow tipping. (With most
LP gas, small yellow tips at the end of outer
cones are normal.) Flames should not lift off
burner ports. If lifting is observed, gradually
reduce air shutter opening until flames are
stabilized.
To remove the oven bottom:
1. Remove the knurled screws holding down rear
of the oven bottom.
2. Grasp the oven bottom at finger slots on
each side.
3. Lift the rear of the oven bottom enough to
clear the lip of the range frame, then pull out.
7
Oven bottom
(continued next page)
Loading ...
Loading ...
Loading ...