Loading ...
Loading ...
Loading ...
www.napoleongrills.com
21
EN
BIM605 BUILT-IN INSTRUCTIONS
3/8”(10mm)
This grill is designed for masonry, NON-COMBUSTIBLE enclosures only, and must be installed and serviced
by a qualied installer to local codes.
1. Aach side mounng brackets to each side of the grill using #1/4-20 x 3/8" screws (N570-0073).
2. Lay the rear trim piece across the back of the opening. To keep it in place, a dab of silicone may be
applied to each wing of the rear trim.
3. Lower the unit in place, the wings on the rear trim should be under the side mounng brackets.
Connect the ex supply line to the ng at the end of the manifold.
4. The enre installaon must be leak tested before operang the unit.
6 x N570-0073 (1/4-20 X 3/8”)
Install baery’s as illustrated. Plug wire from LED (lights) located underneath
control panel into wire from baery pack. Ensure wires do not come in contact
with the boom of the grill. The baery pack module must be mounted inside
the enclosure, at least 8 inches (20cm) below the boom of the drippan, to
prevent the module from overheang. Ensure wires and module do not interfere
with drippan removal.
Loading ...
Loading ...
Loading ...