Loading ...
Loading ...
Loading ...
en Operating the appliance
12
Starting the operation
You must press the l Start/Stop button to start each
operation.
After starting the appliance, the time display is shown
on the display along with the settings. The display ring
and the heating line also appear.
Pausing the operation
You can also interrupt and then continue an operation
using the l Start/Stop button.
If you press and hold the l Start/Stop button for
approx. 3 seconds, the operation is cancelled and all
settings are reset.
Note: The fan may continue to run after an operation
has been paused or cancelled.
Filling the water tank
When you open the appliance door, you will see the
water tank on the right-hand side. Before starting the
operation, fill the water tank with water.
Ensure that you have correctly set the water hardness
range. ~ "Basic settings" on page 18
Caution!
The appliance may become damaged due to the use of
unsuitable liquids.
Do not use distilled water, highly chlorinated tap water
(> 40 mg/l) or other liquids.
Only use cold, fresh tap water, softened water or
uncarbonated mineral water.
Fill the water tank before each use:
1. Open the appliance door.
2. Remove the water tank from the water tank recess
(picture !).
3. Fill the water tank with cold water up to the "max."
mark. (Picture ").
4. Close the tank cover
until you feel it engage.
5. Insert the filled water tank (picture #).
6. Check whether the water tank is pushed in flush with
the water tank recess (picture $).
7. Close the appliance
door.
The water tank has been filled. You can now start the
operation.
Refilling the water tank
If the water tank is empty, the prompt to fill the water
tank appears on the display. The operation is stopped.
:Warning – Risk of scalding!
When you open the appliance door, hot water may flow
out of the appliance. When opening the door, do not
stand too close to the appliance. Open the appliance
door carefully. Keep children away from the appliance.
If the evaporator dish overflows, do not pour more water
into the water tank.
1. Carefully open the appliance door.
2. Remove the water tank and fill it.
3. Slide the water tank back in and close the appliance
door.
4. Start the operation.
The operation continues.
Setting the type of heating and temperature
Example in the picture: 15 minutes steaming S at
90 °C.
1. Touch the left of the field for a type of heating.
The temperature is highlighted in white in the
display.
2
1
+RWDLUJULOOLQJ
PV
P
V
a&
6WHDPLQJ
\PV
6
7
8
%
`
V D
Loading ...
Loading ...
Loading ...