Loading ...
Loading ...
Loading ...
Remove the rubber weather seal
by pulling on the tab.
Insert the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place and clip the end into
the slot.
Install the rubber seal over the
back of the headlight assembly.
Make sure it is right side up; it is
marked ‘‘TOP.’’
Push the electrical connector onto
the tabs of the new bulb. Make
sure it locks in place.
Turn on the headlights to test the
new bulb.
Use a flat-tipped screwdriver to
remove the holding clip from the
inner fender.
Pull the inner fender cover back.
Unclip the hold-down wire from its
slot by pushing it in and up. Pivot
it out of the way and remove the
bulb.
If you are changing the bulb on
the driver’s side, start the engine,
turn the steering wheel all the way
to the right, and turn off the
engine. If you are changing the
bulb on the passenger’s side, turn
the steering wheel to the left.
3.
4.
5.
6.
7.
1.
3.
2.
CONTINUED
Lights
Maintenance
Replacing a Front Turn Signal
Bulb
203
HHOOLLDDIINNGG CCLLIIPP
Main Menu
Table of Contents
Loading ...
Loading ...
Loading ...