Loading ...
Loading ...
Loading ...
English - 19
02 SETTING UP
Connecting the hot water supply hose (selected models)
1. Connect the red L-shaped arm fitting for the hot water supply hose to
the hot water supply intake at the back of the washing machine. Then
tighten it by turning part (A) clockwise by hand.
2. Connect the other end of the hot water supply hose to your sink’s hot
water tap in the same way as you connected the cold water supply
hose.
To use only cold water, use the Y-piece.
A
Connecting the aqua hose (selected models)
The aqua hose was invented to ensure perfect leakage protection.
The aqua stop is attached to the aqua hose and automatically cuts the
water flow if the hose is damaged.
It also displays a warning indicator (A) on the aqua stop.
Connect the aqua hose by assembling the aqua stop on the tap as shown.
A
Connecting the drain hose
The end of the drain hose can be positioned in three ways:
Over the edge of a wash basin
The drain hose must be placed at a height between 60 cm and 90 cm. To
keep the drain hose spout bent, use the supplied plastic hose guide (A).
Secure the guide to the wall with a hook or to the tap with a piece of string
to prevent the drain hose from moving.
(*): 60 ~ 90 cm
A
ln a sink drain pipe branch
The drain pipe branch must be above the sink siphon so that the end of the hose is at least 60 cm above the
ground.
ln a standpipe
We recommend using a 65 cm high vertical pipe as a standpipe. It must be
no shorter than 60 cm and no longer than 90 cm. To keep the drain hose
spout bent, use the supplied plastic hose guide (A). Secure the drain hose
to the standpipe with tie straps to prevent the drain hose from moving.
The standpipe drain requires:
• A minimum diameter of 5 cm.
• A minimum carry-away capacity of 60 litres per minute.
(*): 60 ~ 90 cm
Untitled-16 19 10/5/2016 3:43:43 PM
Loading ...
Loading ...
Loading ...