Loading ...
Loading ...
Loading ...
Some of the appliance's factory default
settings can be changed if desired.
See the chart on the following page for
the different options available.
The original factory settings are marked
in the chart with an asterisk*.
To change a setting, proceed as
follows:
^ Touch X.
In the display, X will flash and P and
0 will light up.
^
Touch OK.
PIwill appear in the display.
^
Use the selector knob to choose the
setting that you wish to change (PI
to P11and P0). Turn it until the
desired setting shows in the display.
^
Then, touch OK to call up the setting.
The status that is currently valid
appears in the display, e.g. S1, etc.
^
Turn the selector knob if you wish to
change the status (see chart), and
confirm your entry by touching OK
(for P8and P0, hold OK for approx.
4 seconds).
The change is then saved to the
memory. P will appear in the display
again, together with the number for the
setting.
The other settings can be changed in
the same way.
If you do not wish to change the setting
shown and would like to move to
another setting, touch #.
^ Touch X if you are finished changing
settings.
Changes to the settings remain
saved during a power outage.
If there is too long of a pause before the
next entry, the clock will reappear in the
display. If this happens, repeat your
entries.
Changing settings
41
Loading ...
Loading ...
Loading ...