Loading ...
Loading ...
Loading ...
English 36
To replace the oven door
Warming Drawer Maintenance
Removing the Drawer
1. Pull drawer to fully open position.
2. Press down right drawer clip.
3. Lift up left drawer clip.
4. Firmly pull the drawer straight out. Retract cabinet rails
while drawer is removed.
Replacing the Drawer
1. Be sure housing slides are pushed inside housing.
2. Align the drawer rails with the housing slides attached
to the drawer housing.
3. Firmly push the drawer straight into the drawer housing
until the drawer clicks into place. Note: The drawer has
a “push-to-open” operation. Pressing the lower center
front of the drawer causes the drawer to self-open.
4. Open and close drawer to test operation. Note: if the
drawer will not close, verify that the rails on the drawer
are properly aligned to housing slides and that the rail
release levers are properly positioned.
1. Holding the door firmly
in both hands, grip it
on either side, not by
the handle.
2. Tilt the door back
slightly towards you
until it opens about 7"
at the top.
3. Slide the hinges into
the slots as far as they
will go and then lower
the door straight
down. The angle of
the door may need to
be adjusted slightly to
allow the hinges to
engage properly and
the door to lower into
place. The door
should lower about
3/4" and stop. If not,
the hinges have not
engaged properly and
the door could fall if it
is released.
4. Once both hinges are
fully engaged as
described in Step 3,
gently open the door
until it is fully open.
5. Push the levers on
both the hinges up
and forward until they
are locked into the
slot, flush with the
front of the oven body.
6. Close and open door
slowly to be sure it is
correctly and securely
in place.
9 CAUTION
To prevent burns, do not remove drawer while hot.
Be sure drawer is empty before removing.
Parts
1 Housing
2 Drawer
3 Housing slide
4 Drawer rail
/2
:
+,*
+
B
0
(
'
35
2
2)
2
1
2)
)
Loading ...
Loading ...
Loading ...