Loading ...
Loading ...
Loading ...
15
REFRIGERATOR INSTALLATION
HOW TO REMOVE THE CUSTOMCHILL™
DRAWER
HOW TO INSTALL THE CUSTOMCHILL™
DRAWER
1. Pull the drawer open to full extension. Remove the
basket by lifting the basket from the rail system.
NOTE : Before removing the CustomChill™ drawer,
it must be disconnected from the
temperature control.
1. Grasp the door on each side and lower it into place
on the rail system.
2. Disconnect the wire harness connection at the end of
the right rail by pressing on the tabs on either side.
It may help to use a small, fl at-blade screwdriver to
apply pressure to the ends of the tabs on either side.
2. Reconnect the wire harness to the connection at the
end of the right rail by aligning the two ends and
pushing them together until you hear a click. The tabs
should snap back into place. Tug gently to make sure
the connection is secure.
NOTE : If you do not reconnect the wire harness
securely, the CustomChill™ drawer will not
work properly.
3. Hold both sides of the door and lift it to remove it
from the rail system.
3. Pull the drawer open to full extension. Lower the
basket onto the rail system.
Loading ...
Loading ...
Loading ...