Loading ...
Loading ...
Loading ...
Control function operation
40
If the start battery is discharged, turn the
“EMERG PARALLEL” switch to the ON posi-
tion to start the engines. Once the engines
are started or the start battery is charged,
turn the “EMERG PARALLEL” switch to the
OFF position.
Main switches
There is a main switch for each engine.
The main switch controls the ignition and
electrical circuits as follows:
AR210 / SX210
1 Main switch (port engine)
2 Main switch (starboard engine)
212X / 212S / 212
1 Main switch (port engine)
2 Main switch (starboard engine)
OFF:
Ignition circuit is switched off. The engine
cannot be started, but other switches will op-
erate. (The main switch key can be removed.)
ON:
Ignition circuit is switched on. (The main
switch key cannot be removed.)
START:
The starter motor will turn to start the engine.
(When the main switch key is released, it re-
turns automatically to “ON”.)
TIP:
The engine will not start when the clip is re-
moved from the engine shut-off switch.
The starter motor will turn over without the
cord attached.
The main switch will not operate (the starter
motor will not turn over) if the battery
switch in the rear underseat storage com-
partment (port) is turned to the OFF posi-
tion. (See page 38 for more information.)
Remote control levers
WARNING
Before shifting, make sure there are no
swimmers or obstacles in the water
near you.
When operating in reverse, go slowly.
Do not open the throttle more than half.
Otherwise, the boat may become unsta-
ble, which could result in loss of control
and an accident.
Do not shift into reverse while traveling
at planing speeds. Loss of control, boat
swamping, or damage to the boat could
occur.
The remote control lever for each engine con-
trols both throttle and shifting. In normal op-
eration, the levers are moved together.
BLOWER
ON
OFF START
1
2
BLOWER
ON
OFF START
1
2
SportsBoat_F3R13.book Page 40 Friday, May 31, 2019 9:42 AM
Loading ...
Loading ...
Loading ...