Loading ...
Loading ...
Loading ...
38
Control function operation
Boat control functions
Engine shut-off switch
WARNING
Always attach the engine shut-off cord
(lanyard) to your PFD before starting the
engines. Failure to attach the cord could
result in a runaway boat if the operator is
ejected.
Do not attach the cord to clothing that
could tear loose. Do not route the cord
in such a way that it could become en-
tangled, preventing it from functioning.
Avoid accidentally pulling the cord dur-
ing normal operation. Once the engines
have stopped, you have no steering con-
trol of the boat which could result in an
accident. Also, without engine power,
the boat could slow rapidly from planing
speed. This could cause people and ob-
jects in the boat to be thrown forward,
which could cause injury.
The clip on the end of the engine shut-off
cord (lanyard) must be attached to the engine
shut-off switch for the engines to run. The
cord must be attached to a secure place on
the operator’s PFD. Should the operator fall
overboard or leave the helm, the cord will pull
out the clip, stopping the ignition to the both
engines. This will prevent the boat from run-
ning away under power.
1 Engine shut-off switch
2 Clip
3 Engine shut-off cord (lanyard)
Battery switch (AR210 / SX210)
The battery switch is located in the rear un-
derseat storage compartment (port).
1 Battery switch
Turn the battery switch to the OFF position
when the boat will not be used again right
away. Turning the switch to the OFF position
will prevent the battery from being drained if
another electrical switch is accidentally left in
the on position. NOTICE : Do not turn the
battery switch to the OFF position if the
boat is moored in the water as it will pre-
vent the anchor light from functioning.
1
2 3
1
SportsBoat_F3R13.book Page 38 Friday, May 31, 2019 9:42 AM
Loading ...
Loading ...
Loading ...