Loading ...
Loading ...
Loading ...
Operation
146
1 Blower switch
(4) 212X / 212S / 212: Turn the main switch
keys to the on position to operate the
blowers automatically for 5 minutes.
TIP:
To operate the blowers manually, tap the
“Blower” button. Ventilate the engine com-
partment for at least 4 minutes, and then tap
the “Blower” button again to turn off the
blowers.
1 “Blower” button
(5) Attach the engine shut-off cord (lanyard)
to your PFD. Install the clip onto the en-
gine shut-off switch by pushing the clip
groove over the nut beneath the knob.
Be sure the cord is not wrapped around
the steering wheel or tangled in the con-
trols. WARNING! Check that the en-
gine shut-off cord (lanyard) is
attached correctly. If the engine shut-
off cord (lanyard) is not attached cor-
rectly, it may not pull free when the
operator falls off, allowing the boat to
continue to run and cause an acci-
dent.
1 Engine shut-off switch
2 Clip
3 Engine shut-off cord (lanyard)
TIP:
The engines will not start when the clip is re-
moved from the engine shut-off switch. The
starter motors will turn over without the cord
attached.
(6) Put the remote control levers in the neu-
tral position. The starter motors will not
operate unless the remote control levers
are in neutral.
(7) Turn the main switch keys to the start po-
sition and release them when the en-
gines start. If the engines do not start
after 5 seconds of cranking, release the
keys. Wait at least 15 seconds before
trying to start the engines again.
BLOWER
1
Dock
Interior
Navigation
Anchor
Ballast
Blower
Bilge
1
2
1
3
SportsBoat_F3R13.book Page 146 Friday, May 31, 2019 9:42 AM
Loading ...
Loading ...
Loading ...