EC860M Instructions for use

Loading ...

2. Place a cup or other container under the milk spout tube.

3. Keepthe“CLEAN”button(g.25) pressed:lights

and

ash. When the lights stop ashing and the

appliancegoesbacktoreadyforuse,releasethe“CLEAN”

button: the steam cleans the circuits inside the milk

frother.

Program the amount of coee and milk in the cup for

cappuccino or milk

The machine has been set by default to deliver standard amounts

ofcoeeandmilk.Ifyouwouldliketoamendthesequantities,

proceed as follows:

1. Place a cup under the coee spouts and the milk spout

tube.

2. Press the button relative to the preparation with milk to

be programmed and keep it pressed. After a few seconds,

the machine starts delivering the milk.

3. Once the required quantity of milk has been delivered into

thecup,releasethebutton;milkdeliverystops.

4. Program the amount of coee into the cup as for the

amount of milk.

5. Programming is conrmed by the lights ashing for 3

seconds.

The machine is now re-programmed according to the new

amounts of milk and coee.

Preparing the hot water and steam

Scalding hazard!

Do not leave the machine unattended when delivering hot

water. The spout heats up during delivery, therefore, only the

black part must be held.

Delivering hot water

1. Checkthehotwaterspoutiscorrectlyattached(g.8).

2. Place a cup under the spout (as near as possible to avoid

sprays).

3. Press the button(B7):therelativelightashesand

the appliance starts hot water delivery.

4. The machine automatically stops delivery.

Please note!

• Tomanuallyinterruptthehotwaterdelivery,press

button again.

Programming the amount of water automatically

delivered

Ifyouwouldliketoamendtheamountofwatersetbydefault,

proceed as follows:

1. Place a cup under the water spout.

2. Keep the button pressed.

3. When the hot water in the cup reaches the required level,

release the button. Programming is conrmed by the

lights ashing for three seconds.

The machine is now re-programmed according to the new

amount.

Delivering steam

1. Checkthehotwaterspoutiscorrectlyattached(g.8).

2. Fill a container with the liquid to be heated/frothed and

immerse the water/steam spout into the liquid.

3. Press twice the button(B7):therelativelightashes

and the appliance starts steam delivery.

4. When the required temperature is obtained, interrupt

steamdeliverybypressingthebuttonagain.(Youshould

not discharge steam for more than 3 minutes at a time).

Important!

Always stop steam delivery before extracting the container

containing the liquid to avoid burns from splashes.

Cleaning the water spout after use

Always clean the spout after use to avoid the build-up of milk

residues and prevent the spout from clogging.

1. Place a container under the cappuccino maker and press

the buttontodeliveralittlewater(g.3).

Stop the ow of water by pressing the button

again.

2. Wait a few minutes for the cappuccino maker to cool

down, then extract the hot water spout.

3. Checktheholeisnotblocked.Ifnecessary,cleanwitha

pin.

4. Wash all parts of the cappuccino maker thoroughly with a

sponge and warm water.

5. Reinsertthewaterspout.

Cleaning

Attention!

• Do not use solvents, abrasive detergents or alcohol to

clean the machine.

• Only the milk container (D) can be washed in the dish

washer. No other part of the appliance can be washed in

the dishwasher.

•

Do not use metal objects to remove coee deposits or

fouling as they might scratch the metal or plastic surfaces.

Instructions for use

Loading ...

Instructions for use - Page 13