Loading ...
Loading ...
Loading ...
21
> Network Functions > Specifications > Advanced Setup > Listening Modes
Troubleshooting Supplementary Information, etc.|
> Basic Manual
MCACC
Setup the speakers automatically or make desired changes to the equalizer. You can also
check the values set currently for each speaker setting.
Operation:
Use the on-screen displays (OSD) that appear on the TV to make the settings.
Press
on the remote controller to display the Home screen, then select MCACC with the
cursors on the remote controller and press ENTER.
Select the item with the cursor / / / buttons of the remote controller and press
ENTER to confirm your selection.
Use the cursors / to change the default values.
•
To return to the previous screen, press .
•
To exit the settings, press .
Full Auto MCACC
Place the supplied speaker setup microphone in the listening position, measure the test
tones emitted by the speakers, then the unit automatically sets the optimum volume level
for each speaker, the crossover frequencies, and the distance from the listening position.
This also automatically adjusts the equalizers for the speakers and enables correction of
distortion caused by the acoustic environment of the room.
•
Calibration takes between 3 and 12 minutes to be completed. The speakers emit the
test tone at high volume during measurement, so be careful of your surroundings. Keep
the room as quiet as possible during measurement.
•
If you have connected a subwoofer, check the power and volume of the subwoofer. Set
the subwoofer volume to more than halfway.
•
If the power of this unit suddenly turns off, the wires in the speaker cables may have
touch the rear panel or other wires and tripped the protection circuit. Twist the wires
again properly and make sure they do not stick out of the speaker terminals when
connecting.
1. Place the supplied speaker setup microphone in the listening position, and connect to
the MCACC SETUP MIC jack on the main unit.
MCACC
SETUP MIC
When putting the speaker setup microphone on a tripod, refer to the illustration when
putting it in place.
2. Select the connected speaker configuration.
Loading ...
Loading ...
Loading ...