Loading ...
Loading ...
Loading ...
28 English
Installation
Installation
5. Attach the ‘Y” connector to the brass
male end of the small hose.
Screw on the coupling by hand until it is
seated on the connector.
6. Using pliers, tighten the coupling with
an additional two-thirds turn.
NOTE
Do not overtighten, as it may damage the
coupling.
7. Attach the angled end of water hoses
(C) to the ll valve at the bottom of the
dryer rear frame. Screw on the coupling
by hand until it is seated on the ll valve
connector.
8. Using pliers, tighten the coupling with
an additional two-thirds turn.
NOTE
Do not overtighten, as it may damage the
coupling.
9. Turn the cold water faucet on.
10. Check for leaks around the “Y” connector,
faucets and hoses.
Final installation check list
• The dryer is plugged into an electrical outlet and grounded properly.
• The exhaust ductwork is hooked up and the joints are taped.
• You have used rigid or stiff-walled exible metal duct material, not plastic exible duct.
• The dryer is level and is sitting rmly on the oor.
• For gas models: The gas is turned on and there are no gas leaks.
• Start your dryer to conrm that it runs, heats, and shuts off.
DV8000J-03170M-01_EN-US_150122.indd 28 2015/1/23 16:29:59
Loading ...
Loading ...
Loading ...