User manual Vacuum Cleaner
Intended Use
- The vacuum cleaner is intended for vacuuming and extracting materials that are not hazardous to one's health.
- The vacuum cleaner is intended for commercial/indoor use, for example in department, house, hotels, schools, factories, shops, offices and rental businesses recommended by manufacturer.
Technical Data
Remark:
The primary function of cyclone isolates the dust to the bottom of cyclone, instead of on the combed grid, Adopting the cyclone technology, the vacuum cleaner can suction the granular dust precipitated on the bottom of the container, reduce the probability of the metal mesh blocked by cotton wool , greatly reduce the cleaning frequency of the filter, effectively extend the life-time, and make your experience better & more comfortable!
Introduction of Components
Main body:
Wall mounted:
Assembly
- Before vacuuming, ensure that the filter assembly is assembled securely. Attach the battery to the dust cup as (a).
- Attach the metal tube to the body until you hear a click (b).
- Attach the dust cup and battery to the top of the tube until you hear a click (c).
- Attach a brush head.
- Adjusting the vacuuming power. Press the power switch to begin operation. The “Standard" vacuuming power stage is set by default.
Insert your selected accessory (bristle brush or long crevice) into the vacuum body as shown below:
Starting Operation
Charging the Battery
Charging time: 4-5 hrs
- Low power: battery indicator blinks in blue when in use , please turn off the appliance, and then charge it.
- Charging :3 blue lights are illumi nated one by one.
- Fully charged: 3 blue lights remain on.
During operation, indicator lights will show the following:
Blue - On/ low speed
Pink - High speed
Red - Brush head is jammed
Empty the Dust Cup
Maintaining the Filter
1. Press the battery pack button to remove the battery.
2. Open the dust cup as shown below.
3. Remove the filter case, and then remove the filter.
4. Wash the filter case.
5. Using the Cleaning Brush
A. Use the brush side to clean the metal mesh and inner filter:
B. Use the knife side to remove tangled hairs or debris from the brush roller.
6. Installing wall-mounted Adhesive 3M, recom mending to suspend the vacuum cleaner after 24 hours.
- Do close floor brush to the ground when the machine is suspended.
- Do use expansion screw to attach machine on the wall or attachment surface when dangling.
Troubleshooting
Weak suction
- Empty the dust cup.
- Clean the HEPA filter.
- Check if the dust cup is installed correctly.
Roller brush stops spinning or emits unusual noise
- Check if the brush (especially the bearing) is tangled with hair.
- Check if the filter cup is installed correctly.
- Detach the tube, and use the handheld part only. If this does not work, contact the seller for help.
Battery doesn't hold a charge
- Check if the vacuum cleaner is fully charged with 3 lights on.
- Check if the charger & charging base are connected correctly.
- If there is no light on when charging, contact the seller for help.
