Loading ...
Loading ...
Loading ...
English - 10
installation
Safety instructions for the installation
This oven may be installed only by an approved electrician. The installer is responsible for connecting the
appliance to the main supply, while observing the relevant safety regulations.
•
Ensure protection from live parts when installing the oven.
Power connection
If it is not possible to connect the appliance to the mains with a plug due to allowable
current limitations, a multi-pole isolator switch (with at least 3 mm contact spacing) must
be provided in order to satisfy safety regulations. The power cable (H05 RR-F or H05
VV-F, min., 2.5 mm²) must be of sucient length to be connected to the oven, even if the
oven stands on the floor in front of its built-in cabinet. Open the rear connection cover
of the oven with a screwdriver and loosen the screws of the cable clamp before you
connect the power lines to the relevant connection terminals. The oven is earthed via the
( )-terminal. The yellow and green cable(earth connection) must be connected first
and be longer than the others. If the oven is connected to the mains with a plug, this plug must remain accessible after the
oven is installed. Samsung will take no responsibility for accidents that originate from a missing or faulty earth connection.
WARNING: Do not allow the connecting cable to become trapped during
installation, and prevent it coming into contact with hot parts of the oven.
Installation in the cabinet
With built-in furniture, plastic surfaces and adhesive for the oven should be resistant to 90 °C inside of
the furniture and to 75 °C for adjacent furniture. Samsung will take no responsibility for damage of plastic
surfaces or adhesive from the heat.
There should be a ventilation gap in the base of the kitchen cabinet where the oven is to be placed. For
ventilation, a gap of about 50mm should be left between the lower shelf and the supporting wall. If the
oven is to be installed below a hob, the hob’s installation instructions should be followed.
Push the appliance completely into the cabinet and fix the oven firmly on both sides using 2 screws. Make
sure that a gap of at least 5mm should be left between the appliance and the adjacent cabinet.
After installation, remove the vinyl protective film, tape, paper and accessories from the door and inside
of oven. Before uninstalling the oven from the furniture, disconnect the oven from the power supply and
release the 2 screws on the both sides of the oven.
WARNING: The built-in furniture must have a minimum ventilation gap for Air-flow as shown
on picture. Do not cover this hole with strips of wood, for this is used to provide ventilation.
The front exterior of the oven such as handle is dierent model by model. But the size of the
oven in the picture is same.
595
370
560
545
21
595
Max.50
Min.550
Min.560
Min.50
Min.590 ~ Max.600
Min.460 x Min.50
Built-in
055
550
275
572
595
370
560
545
21
115
595
175
Max.464
Min.550
Min.560
Min.600
Min.460 x Min.50
Built-under
Built-in + Built-under
055
550
275
572
Max.476
BROWN
or BLACK
BLUE or
WHITE
YELLOW
and GREEN
NV70F5787LB_EU_DG68-00522G-05_EN.indb 10 2017-03-30 4:38:27
Loading ...
Loading ...
Loading ...