Loading ...
Loading ...
Loading ...
E-28
Do not splash water on the unit. Doing so may cause a unit failure.
Do not use volatile solvents, such as gasoline, thinner, benzene, wax, kerosene, alcohol, etc. or polishing powder, or deter-
gent (used for kitchen or laundry). Such chemicals could cause deformation, discoloration, damage or removal of print labels.
When using a chemically treated cloth, follow safety instructions.
Do not use a dryer or heater to dry the unit. Heating could cause deformation, discoloration, damage or removal of print labels.
Lay a soft cloth or similar material beneath and around the purifi er body to protect the fl oor against scratches
and from getting wet.
Do not tilt or tip over the unit.
Cleaning
Do not stop operation by unplugging the power plug.
Otherwise, it may cause fi re, electric shock or unit failure.
When the Filter Cleaning Indicator Comes On
The indicator lights up approximately 240 hours of performing the humidifying operation after the reset button was
pressed. (Guide for cleaning)
The humidifying system employed in this product is the evaporating type that produces moisturized air by passing
an air stream through the humidifying fi lter.
Depending on the application environment, dirt or odor may adhere to the humidifying fi lter even when the “Humidify”
or “Skin Moist” mode is not activated. Please clean immediately.
When "Humidify" or "Skin Moist" mode is used, be sure to use tap water for the water tank.
Although the humidifying fi lter has been treated against bacteria and mold, it may get slimy or moldy, or may be-
come discolored to pink, red, green, brown, black or gray after a short period of use depending on the quality of tap
water used, and the application environment. (Discoloration has no effect on humidifying performance.)
It is recommended that the fi lter be cleaned as often as practicable regardless of whether the “Filter Cleaning” indicator lights up or not.
Early replacement of the fi lter is recommended if it exhibits any of the following conditions despite periodic cleaning.
·
Heavy dirt is present, attached hardened water scale is diffi cult to remove, bad odors, serious damage or deformation
If the “Humidify” or “Skin Moist” operation mode is not in use, drain the remaining water from the “Water Tank” and
“Water Tray”. It can cause dirt build up or discoloration.
Humidifying filter
Check if the operation has stopped before removing the power plug from the socket
While operating, press the power button and stop operation.
1
2
CAUTION
Lay a towel
Side cover
Humidifying filter
Water tray
Open the side cover and remove the
humidifying filter with the water tray
There might be some water remaining in the water tray.
Slightly pull out the water tray, hold it levelly and take it
out.
It is also recommended that you lay a towel.
Since the bottom part of the unit has casters,
hold down the unit while removing the water
tray.
(The casters do not have stoppers)
Water might leak if there is remaining water
in the water tray and it is tilted.
WARNING
CAUTION
EP-A9000_EN.indd 28EP-A9000_EN.indd 28 11/18/2014 11:02:17 AM11/18/2014 11:02:17 AM
Loading ...
Loading ...
Loading ...