Loading ...
Loading ...
Loading ...
E-24
Operating in PM2.5 Sensor
Note
Operation modes other than “Air Purify” cannot be set.
While operating in PM2.5 sensing, the air sensor will light up, then enlarge and shrink slowly.
For the fi rst 90 seconds of operation, the unit will operate in “Max” airfl ow rate (air sensor: red).
The fl ap direction will be diagonal.
It will not respond to the switching of sensor sensitivity.
(P.E-27)
Switching Between Temperature / Humidity Monitor Display
Useful Features
(Continued)
Change into a sensor that is suitable for small particles, like PM2.5 (general term for micro particles be-
low 2.5µm). The level of contamination in the air will be detected by the dust sensor, and the unit will op-
erate automatically between “Medium” to “Max” airfl ow rate.
(Odor sensor control will not be performed)
Tap to set PM2.5 sensing.
Each tap will switch between Off (Clear) to On (Set).
Off On
PM2.5
Sensor
Temperature / Humidity monitor display alternately shows both temperature and humidity.
Touch to switch display.
The display will switch between humidity (%) and temperature (°C) each time the button is touched.
Humidity (%) Temperature (°C)
Display
Stopping Operation Using Timer
No Display 2hr 4hr
No Display: Not Set
2hr : Automatic stop after about 2 hours of operation
4hr : Automatic stop after about 4 hours of operation
Touch to set the timer.
At each touch the following display will be appear on the display for setting.
Timer
Set the off-timer.
EP-A9000_EN.indd 24EP-A9000_EN.indd 24 11/18/2014 11:02:16 AM11/18/2014 11:02:16 AM
Loading ...
Loading ...
Loading ...