Loading ...
Loading ...
Loading ...
18 19
CARE AND CLEANING
To prepare your new machine for initial use, follow
the steps under Normal Cleaning, below. This will
clean the unit and break in the motor.
During your first few uses, you may notice a slight
burning odor as the motor is primed.
This is completely normal and will dissipate quickly.
Container
To prepare your new machine for initial use, follow the steps under Normal
Cleaning, below. This will clean the unit and break in the motor.
CARE AND CLEANING
Normal Cleaning:
Before using the Variable-Speed option, always begin with the Variable-Speed
Dial marker pointing to the Stop Symbol (
) at the top of the dial.
1. Fill the container half full of warm water and add a few drops of washing-up
liquid to the container.
2. Snap or push the complete 2-part lid into the locked position.
3. Perform one of the following procedures:
• Variable Speed:
a. Rotate the Variable-Speed dial to 1.
b. Press the Start / Stop switch.
c. Slowly increase variable speed to 10.
d. Run the machine for 30 to 60 seconds.
e. Rotate the Variable-Speed dial to the Stop Symbol (
) at the top of
the dial.
• Programme:
a. Rotate the Variable-Speed dial to the Cleaning (
) programme
icon. The Cleaning (
) programme will run for approximately
1minute.
b. After the programme stops, rotate the Variable-Speed dial to the
Stop Symbol (
) at the top of the dial.
4. Rinse and drain the container.
To Sanitise:
Before using the Variable-Speed option, always begin with the Variable-Speed
Dial marker pointing to the Stop Symbol (
) at the top of the dial.
1. Follow the cleaning instructions above.
2. Fill the container half full of water and add 1 ½ teaspoons of liquid bleach.
3. Snap or push the complete 2-part lid into the locked position.
4. Perform one of the following procedures:
• Variable Speed:
a. Rotate the Variable-Speed dial to 1.
b. Press the Start / Stop switch.
c. Slowly increase variable speed to 10.
d. Run the machine for 30 to 60 seconds.
e. Rotate the Variable-Speed dial to the Stop Symbol (
) at the top
of the dial.
• Programme:
a. Rotate the Variable-Speed dial to the Cleaning (
) programme
icon. The Cleaning (
) programme will run for approximately
1minute.
b. After the programme stops, rotate the Variable-Speed dial to the
Stop Symbol (
) at the top of the dial.
5. Allow the mixture to stand in the container for an additional 1 ½ minutes.
6. Pour out bleach mixture. Allow container to air dry.
7. Do not rinse after sanitising.
Lid, Lid Cap and Tamper
Separate the lid and lid cap. Wash parts in warm, soapy water. Rinse clean under
running water and dry. Reassemble before use.
IMPORTANT: To ensure continued and eective performance, do not put the
container, lid, lid cap or tamper in the dishwasher.
Motor Base
1. Unplug the power cable.
WARNING
Electrical Shock Hazard.
Always unplug before cleaning the
motor base or when not in use.
Do not put the motor base in water or
otherliquid.
Failure to follow instructions can cause
death or electrical shock.
Loading ...
Loading ...
Loading ...