Owner's Manual - Page 223

For LEON 5D 2008.

Loading ...
Loading ...
Loading ...
Wheels and tyres222
Wheels and tyres
Wheels
General notes
Avoiding damage
If you have to drive over a kerb or similar obstacle, drive very
slowly and as near as possible at a right angle to the kerb.
Keep grease, oil and fuel off the tyres.
Inspect the tyres regularly for damage (cuts, cracks or blisters,
etc.). Remove any foreign objects embedded in the treads.
Storing tyres
Mark tyres when you remove them to indicate the direction of
rotation. This ensures you will be able to install them correctly
when you replace them.
When removed, the wheels and/or tyres should be stored in a
cool, dry and preferably dark location.
Store tyres in a vertical position if they are not fitted on wheel
rims.
New tyres
New tyres have to be run in page 182.
The tread depth of new tyres may vary, according to the type and make of tyre
and the tread pattern.
Concealed damage
Damage to tyres and rims is often not readily visible. If you notice unusual
vibrations or the car pulling to one side, this may indicate that one of the tyres
is damaged. The tyres should be checked immediately by an Authorised
Service Centre.
Tyres with directional tread pattern
An arrow on the tyre sidewall indicates the direction of rotation on tyres with
directional tread. Always observe the direction of rotation indicated when
fitting the wheel. This guarantees optimum grip and helps to avoid aqua-
planing, excessive noise and wear.
WARNING
New tyres do not have maximum grip in the first 500 km. Drive particu-
larly carefully to avoid risk of accident.
Never drive with damaged tyres. This may cause an accident.
If you notice unusual vibration or if the vehicle pulls to one side when
driving, stop the vehicle immediately and check the tyres for damage.
Checking tyre pressure
The correct tyre pressure can be seen on the sticker on the
inside of the tank flap.
1. Read the required tyre inflation pressure from the sticker. The
values refer to Summer tyres. For Winter tyres, you must add 0.2
bar to the values given on the sticker.
leon_ingles Seite 222 Montag, 26. Januar 2009 4:29 16
Loading ...
Loading ...
Loading ...