Loading ...
Loading ...
Loading ...
GETTING READY — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
—
36
Pulling up the bobbin thread
When making gathers or before free-motion quilting,
first pull up the bobbin thread as described below.
a
Insert the bobbin into the bobbin case.
• Refer to steps
a through e of “Installing the
bobbin” (page 26).
b
Pass the bobbin thread through the slot.
Do not cut the thread with the cutter.
c
Turn on the sewing machine.
d
While lightly holding the upper thread with
your left hand with the needle in the up-
position, press (needle position button)
twice to lower and raise the needle.
a Needle position button
X The bobbin thread is looped around the
upper thread and can be pulled up.
e
Carefully pull the upper thread upward to pull
out the end of the bobbin thread.
f
Pull out about 10 cm (4 inches) of the bobbin
thread under the presser foot toward the rear
of the machine.
g
Turn off the sewing machine.
h
Reattach the bobbin cover.
Insert the tab in the lower-left corner of the
bobbin cover (A), and then lightly press down
on the right side (B).
1
AA
B
Loading ...
Loading ...
Loading ...