Loading ...
Loading ...
Loading ...
English - 28
Before calling service
- Any sounds you hear when the ice maker
dumps ice into the bucket are part of normal
operation.
- If you don’t dispense ice for a long period of
time, the ice may form clumps in the ice bucket.
If ice clumps form, remove the remaining ice
and empty the bucket.
- When ice does not come out, check for ice
stuck in the chute and remove it.
Figure 3
Ice Chute
• When Ice O blinks on the display panel,
reinsert the bucket and/or make sure it’s
installed properly.
• When the door is open, the Ice and water
dispenser do not work.
• If you close the door hard, it may cause water
spilling over the ice maker.
• To prevent dropping the ice bucket, use both
hands when removing it.
• To prevent injury, be sure to clean up any ice or
water that may have dropped on the floor.
• Do not let the children hang on the ice
dispenser or on the bucket.
They may get hurt.
• Be sure not to put your hand or any object into
the ice chute.
It may cause personal injury or damage
mechanical parts.
CAUTION
Check the amount of water supplied to
the ice tray.
1. Lift up the icemaker cover and gently pull it out.
2. When you press the Test button for 3 seconds,
the ice cube container is filled with water from
the water supply tap.
Check to make sure the amount of water is
correct (see the illustration below).
If the water level is too low, the ice cubes will be
small.
Check to make sure the water is inside of the
Tank o.
Ice maker
1
Test button
2
Check the water level
• It will take a few minutes for the water to
reach the correct level after you push the
Test button.
• Do not press the test button continuously when
the tray is filled with ice or water.
Water may overflow or ice jamming may occur.
• When the bucket is not installed, the ice maker
does not work.
• When Ice O blinks on the display panel,
reinsert the bucket and/or make sure it’s
installed properly.
CAUTION
DA68-03281A (EN)-03.indd 28 2017. 7. 7. �� 2:24
Loading ...
Loading ...
Loading ...