Loading ...
Loading ...
Loading ...
INSTALLATION INSTRUCTIONS
3
DIMENSIONS
This appliance is 42 inches (106.7 cm) wide, 16
inches (40.8 cm) high and 23.9 inches (60.6 cm)
deep.
WALL SLEEVE
All wall sleeves used to install the air conditioner
must be in good structural condition and have a
rear grille that securely attaches to the sleeve or the
fl ange of the sleeve to secure the appliance.
Install the wall sleeve according to the wall sleeve
installation instructions. When installing the sleeve
make certain there is nothing within 20 inches (50.8
cm) of the back of the appliance that would interfere
with heat radiation and exhaust air fl ow.
INSTALLATION
1. Remove the front panel. Pull out from the bottom
to release it from the tabs and then lift up.
2. Remove the shipping screw from the vent door.
3. Rotate the vent control lever to either open or
close the vent door. When the vent control lever
is set to “close”, only the air inside the room is
circulated. When the vent control lever is set to
“open”, outdoor air will be drawn into the room.
This can reduce heating or cooling effi ciency.
4. Lift the appliance and slide it into the wall sleeve
until it is set fi rmly against the front wall of the
sleeve and secure with four screws through the
fl ange holes.
5. Reinstall the front panel. Place the tabs over the
top rail and push inward at the bottom until the
panel snaps into place.
1
2
3
4
4
5
Loading ...
Loading ...
Loading ...