Loading ...
Loading ...
Loading ...
.
Adjust the "LO" or "SIMMER" Setting of Surface
Burner Valves (see Figure 15}
Push in and turn each control knob to the "LO" (or
"SIMMER") setting. The"LO" setting of each
burner has been set at the factory to the lowest
setting available to provide reliable reignition of the
burner. If it does not stay lit on the"LO" setting,
check the setting as follows.
_Be extremely careful when performing
this operation.
A. Allow cooktop to cool to room temperature.
B. Light all burners by turning each control knob to
LITEuntil burners ignite, and then set them at
"HI".
C. _turn the knob to tile LOWESTPOSITION
for the burner you want to adjust.
D. If burner goes out, readjust valve asfollows:
Remove the surface burner control knob, insert a
thimbladed screw driver into the hollow valve
stem and engage tile slotted screw inside. Flame
size can be increased or decreased with tile turn
of the s(rew. To increase flame size turn the
s(rew counterclockwise and to decrease turn
clockwise. Adjust flame until you (:an quickly
turn knob from HI to LOWESTPOSITIONwithout
extinguishing tile flame. Flame should be as
small as possible without going out.
E. If you need to adjust another burner, repeat the
steps from A to D above until all burners operate
properly.
Valve Stem
Figure 15
When All Hookups are Complete
Make sure all controls are left in the OFF position.
Make sure the flow of combustion and ventilation air to
the cooktop isunobstructed.
Model and Serial Number Location
The serial plate is located into the burner box near the
burner support or under the burner box.
When ordering parts for or making inquires about your
range, always be sure to include tile model and serial
numbers and a lot number or letter from the serial plate
of your cooktop.
Your serial plate also tells you the rating of the burners,
tile type of fuel and the pressure the cooktop was
adjusted for when it left tile factory.
Improper installation adjustment,
alteration, service or maintenance can cause injury
or property damage. Refer to this manual. For
assistance or additional information consult a
qualified installer, service agency, manufacturer
(deater) or the gas supplier.
Stepping, leaning or sitting on these
cooktops can result in serious injuries and also
cause damage to the cooktop.
Be sure to keep appliance clear of combustibJe
materials, gasoline and other flammable vapors and
liquids.
Before You Call for Service
Read the Before You Call for Service Checklist and
operating instructions in your Use and Care Guide. It
may save you time and expense. Tile list includes
common o(currences that are not the result of defective
workmanship or materials in this appliance.
Refer to your Use and Care Guide for Sears service
phone numbers, or call 1-800-4-MY-HOME ®, Pleasecall
if you have inquiries about your product and/or need to
order parts.
Cooktop Removal
If removing the cooktop is necessary for cleaning or
maintenance:
1.Shut off gas supply.
2.Disconnect the gas and electric supply.
3.Remove the installation screws which secure the unit
to the cabinet at the front and rear or the mounting
brackets on the right and left side of the burner box.
4.Remove the unit for servicing and cleaning.
Reinstall in opposite manner and order of removal and
check gas connection for leaks.
Loading ...
Loading ...
Loading ...