Loading ...
Loading ...
Loading ...
Safety on the Cooktop
Do not allow dry empty pans to heat on the cooktop as
this could ruin the pan and cause a fire hazard.
Do not use a wok on the cooking surface if it is
equipped with a round metal support placed over the
burner grate. This support acts as a heat trap which
may damage the burner grate, drip bowls and burner
head. It may also cause the burner to work improperly
and create a carbon monoxide hazard.
When lowering the cooktop be careful not to pinch
your fingers. Grasp sides of the top with fingertips and
lower into position.
important: Please Read Before Continuing
This appliance and its individual shutoff valve must be
disconnected from the gas supply piping system during
any pressure testing of that system exceeding Y2psig.
This appliance must be isolated from the gas supply
pipping system by (losing its individual manual shutoff
valve during any pressure testing of the gas supply piping
system equal to or lessthan Y2psig.
These cooktops are not approved for use
with downdraft systems.
Disconnect the electrical supply before
servicing cooktops.
1. WanNOut_et Location
10"
(/i ΒΈj J
Recommended area for
120V grounded outlet
on rear wall.
22"
', NOTE: If an outlet
is not available,
have one installed by
i a qualified technician. _,
UNiT
Figure S
2_ Secure the Unit
Unit Clamp Down information
Once the cooktop is installed and centered in the
counter opening, you must (:lamp the unit down as
shown. To (:lamp down, insert the offset side of the
angle bracket into the slots on each side of the unit.
Then run the thumb screw through the bracket and
up against the bottom of the counter. Tighten until
the unit draws down (figure 4).
Cooktop
Countertop
Angle Bracket
Burner Box
Figure 4
Loading ...
Loading ...
Loading ...