Loading ...
Loading ...
Loading ...
9
USING THE RANGEHOOD
Touch control operation
fan
Fan – select speed to suit cooking conditions
Low – light frying/boiling
Medium – frying/wok cooking/heavy boiling
High – grilling, intensive frying and wok cooking.
Switch lights ON and OFF
Touch the ‘light’ symbol to turn the lights ON, if
adjustment to light intensity is required continue to touch
and hold until required brightness is achieved.
Touch ‘light’ symbol again to turn the lights OFF.
Timer
At the end of cooking, if the timer is switched on, the
rangehood will continue to run for an additional 5 to 15
minutes, depending on the selected fan speed.
The fan speed is reduced in 5 minute increments until the
rangehood turns itself OFF.
i.e. if the fan speed is set on high, it will run for 5 minutes
then reduce to medium for 5 minutes, then reduce to low
for 5 minutes before finally turning itself OFF.
This should ensure the removal of any odours that remain
after cooking.
Filter
This is the indicator/switch to show when the
filter needs to be cleaned.
Once the filters are cleaned the “Filter” alert can
be deactivated with a single touch.
MAINTENANCE AND CLEANING
CAUTION!
• Before maintenance or cleaning is carried out,
the rangehood should be disconnected from
the main power supply. Ensure that the rangehood
is switched off at the wall socket and the plug
removed.
• External surfaces are susceptible to scratches
and abrasions, so please follow the cleaning
instructions to ensure the best possible result is
achieved without damage.
• These instructions must be followed to aviod a
risk of fire.
Stainless steel surface
Clean stainless steel surfaces using non-abrasive cleaning
products that are specifically for use on stainless steel.
To ensure best results also use an even pressure and
follow the grain of the stainless steel. Use of a soft cloth
reduces the risk of scratching. If the cloth is wet ensure
that a dry soft cloth is used to wipe down the surface
again reducing the risk of any surface rust appearing.
Control panel surface
The control panel can be cleaned using warm soapy
water. Ensure the cloth is well wrung before cleaning.
Use a dry soft cloth to remove any excess moisture left
after cleaning.
Cleaning grease filters
The mesh filters can be cleaned by hand in warm soapy
water. Soak in warm water and some washing up liquid.
For stubborn grease stains use a soft nylon brush to help
remove these stains. After cleaning ensure that the filters
are completely dry before refitting.
CHANGING THE HALOGEN LAMPS
Ensure lamp is cool before removing.
To remove the lamp, apply pressure to the lamp and turn
anti-clockwise to unscrew and remove. Replace the lamp
with one of similar type and voltage.
Loading ...
Loading ...
Loading ...