Loading ...
Loading ...
Loading ...
35
Complete Installation Checklist
❑
Check that all parts are now installed. If there is an
extra part, go back through the steps to see which step
was skipped.
❑
Check that you have all of your tools.
❑
Dispose of/recycle all packaging materials. Keep the plastic
foam (24" [61 cm] models) for use if the washer/dryer should
be transported.
❑
Check the washer/dryer’s nal location. Be sure the vent
is not crushed or kinked.
❑
Check that the washer/dryer is level and leveling feet are
tight (24" [61 cm] models). See “Level Washer/Dryer.”
Electric Models (In the U.S.A.):
❑
240V models: For power supply cord installation, plug
into a grounded 4 prong or 3 prong outlet. For direct
wire installation (27" [69 cm] models only), turn on power.
❑
120V models: Plug into a grounded 3 prong 20 amp
outlet.
Electric Models (In Canada):
❑
240V models: Plug into a grounded 4 prong outlet.
❑
120V models: Plug into a grounded 3 prong 20 amp
outlet.
Gas Models (In the U.S.A. and Canada):
❑
Plug into a grounded 3 prong outlet.
All Models (In the U.S.A. and Canada):
❑
Check that the water faucets are on.
❑
Check for leaks around faucets and inlet hoses.
❑
Remove the lm on the console and any tape remaining
on the washer/dryer.
❑
Read the Washer/Dryer Use and Care Guide.
❑
Wipe the dryer drum interior thoroughly with a damp cloth
to remove any dust.
❑
To test the washer, measure 1/2 the normal recommended
amount of detergent and pour it into the washer. Close the
lid. Select Heavy Duty or Heavy (depending on model) and
push START/PAUSE. Allow the washer to complete one
whole cycle.
❑
To test the dryer, set the dryer on a full heat cycle
(not an air cycle) for 20 minutes and start the dryer.
If the dryer will not start, check the following:
• Controls are set in a running or On position.
• Start button has been rmly pushed.
• Washer/dryer is plugged into a grounded outlet.
• Electrical supply is connected.
• Household fuses are intact and tight, or circuit breakers
have not tripped.
• Dryer door is closed.
❑
When the dryer has been running for 5 minutes, open the
dryer door and feel for heat.
If you do not feel heat, turn off the dryer and check the
following:
• Electric dryers: There may be two household fuses
or circuit breakers for the dryer. Check that both fuses
are intact and tight, or that both circuit breakers have
not tripped. If there is still no heat, contact a quali ed
technician.
• Gas dryers: Check whether the gas supply line shut-
off valve is open. If it is closed, open it, then repeat the
5-minute test as outlined above. If it is open, contact a
quali ed technician.
NOTE: On electric models, you may notice an odor when
the dryer is rst heated. This odor is common when the heating
element is rst used. The odor will go away.
Plug In Washer/Dryer:
24" (61 cm) 120V Electric Models
1. Plug into a grounded 3 prong
20 amp (5-20R) outlet
Loading ...
Loading ...
Loading ...