Loading ...
Loading ...
Loading ...
27
Vent System Chart, 27" (69 cm) Models
Number of 90°
turns or elbows
Type
of vent
Angled
hoods
1
2
0 Rigid metal
Rigid metal
Rigid metal
35 ft. (10.7 m)
27 ft. (8.2 m)
19 ft. (5.8 m)
The Vent System Chart provides venting requirements that
will help achieve best drying performance.
NOTE: Side exhaust installations (24" [61 cm] models only)
have a 90º turn inside the dryer. To determine maximum
exhaust length, add one 90º turn to the chart.
Determine vent length and elbows needed for best
drying performance:
n Use following Vent System Chart to determine type of vent
material and hood combinations acceptable to use.
NOTE: Do not use vent runs longer than those speci ed
in Vent System Chart. Exhaust systems longer than those
speci ed will:
n Shorten life of dryer.
n Reduce performance, resulting in longer drying times
and increased energy usage.
Install Vent System
1. Install exhaust hood
12" min.
(305 mm)
12" min.
(305 mm)
2. Connect vent to exhaust hood
Install exhaust hood and use caulking compound to seal
exterior wall opening around exhaust hood.
Vent must t inside the exhaust hood. Secure vent to exhaust
hood with 4" (102 mm) clamp. Run vent to dryer location using
straightest path possible. Avoid 90° turns. Use clamps to seal
all joints. Do not use duct tape, screws, or other fastening
devices that extend into interior of vent to secure vent,
because they can catch lint.
Vent System Chart, 24" (61 cm) Models
Number of 90°
turns or elbows
Type
of vent
Angled
hoods
1
2
0 Rigid metal
Rigid metal
Rigid metal
36 ft. (11.0 m)
26 ft. (7.9 m)
16 ft. (4.9 m)
Vent System Chart,
27" (69 cm) Long Vent Models
WETLV27H and WGTLV27H (U.S. Only)
Number of
90° turns
or elbows
Type
of vent
Angled
hoods
1
2
0 Rigid metal
Rigid metal
Rigid metal
125 ft. (38.1 m)
115 ft. (35.1 m)
105 ft. (32.0 m)
3 Rigid metal
4 Rigid metal
5 Rigid metal
95 ft. (29.0 m)
85 ft. (25.9 m)
75 ft. (22.9 m)
Loading ...
Loading ...
Loading ...