Loading ...
Loading ...
Loading ...
9
30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
(Models with Sealed Top Burners)
BACK EDGE OF
RANGE LINE OR
REAR WALL
REAR WALL
ANTI-TIP
BRACKET
C
L
10
(25.4 cm)
Toe
Plate
Door
Cabinet
Kitchen
Cabinet
SLIDE
BACK
(
C
L = Center line)
Range
Anti-Tip Bracket
Floor Mount
Screws
Floor
Rear of Range
Wall
1. Draw a center line (CL) on the oor where the range
should be installed. Also draw a line on the oor at
the range back position if there is no wall.
2. Unfold paper template and place it at on the oor
with the right rear corner positioned exactly on the
intersection of the center and back lines you just
drew before. (Use the diagram below to locate
brackets if template is not available (Figure 6)).
3. Mark on the oor the location of the 4 mounting holes
shown on the template. For easier installation, 3/16"
(0,48 cm) diameter pilot holes 1/2" (1,27 cm) deep
can be drilled into the oor.
4. Remove template and place bracket on oor. Line up
holes in bracket with marks on oor and attach with
4 screws provided. Bracket must be secured to solid
oor (Figure 7). If attaching to concrete oor, rst drill
3/16" (0,48 cm) dia. pilot holes using masonry drill bit.
5. Be sure the 4 leveling legs are at the highest position
they can be.
6. Slide range into place making sure structure of the
range is trapped by the anti-tip bracket (Figure 7).
Lower the range by adjusting the 4 leveling legs until
the underside of the cooktop is sitting level on the
countertop. Refer to "Leveling the Range" section.
7. After installation, verify that the anti-tip bracket is
engaged by grasping the top rear edge of the range
and carefully attempt to tilt it forward to make sure
range is properly anchored.
8.
Anti-Tip Brackets Installation
Instructions
8.1
Models Equipped with Leveling Device
To reduce the risk of tipping of the range,
the range must be secured to the oor by properly installed
anti-tip bracket and screws packed with the range. These
parts are located in the oven. Failure to install the anti-tip
bracket will allow the range to tip over if excessive weight
is placed on an open door or if a child climbs upon it.
Serious injury might result from spilled hot liquids or from
the range itself.
Follow the instructions below to install the anti-tip
brackets.
If range is ever moved to a different location, the anti-
tip brackets must also be moved and installed with the
range.
Tools Required:
Adjustable Wrench
Ratchet
Drill & 1/8" (0,32 cm) bit
5/16" (0,8 cm) Nutdriver
Level
The anti-tip bracket attaches to the oor at the back of
the range to prevent range from tipping. When fastening
bracket to the oor, be sure that screws do not penetrate
electrical wiring or plumbing. The screws provided will
work in either wood or concrete.
Figure 6
Figure 7
Loading ...
Loading ...
Loading ...