Loading ...
Loading ...
Loading ...
11
30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
(Models with Sealed Top Burners)
9.
Range Installation
Important Note: Door removal is not a requirement for
installation of the range, but is an added convenience.
Refer to the Use
and Care Guide for
oven door removal
instructions.
Standard Installation
9.1
The range cooktop overlaps the countertop at
the sides and the range rests on the oor. The
cooktop is 31 1/2" (80 cm) wide.
9.2
Install base cabinets 30" (76,2 cm) apart. Make
sure they are plumb and level before attaching
cooktop. Shave raised countertop edge to clear
31 1/2" (80 cm) wide range top rim.
9.3
Install cabinet doors 31" (78,7 cm) min. apart so it
will not interfere with range door opening.
9.4
Cutout countertop exactly as shown on page 4.
For models equipped with Leveling Device:
9.5
Make sure the front leveling legs and the rear
leveling device are setup higher than the height
of the cabinet.
9.6
Install the anti-tip bracket at
this point before placing the range at its nal
position. Follow the installation instructions on
page 9 or 10 or on the anti-tip bracket template
supplied with the range.
9.7
To provide an optimum installation, the top
surface of the countertop must be level and
at (lie on the same plane) around the 3 sides
that are adjacent to range cooktop. Proper
adjustments to make the top at should be made
or gaps between the countertop and the range
cooktop may occur.
9.8
To reduce the risk of damaging
your appliance, do not handle or manipulate it by
the cooktop or control console. Manipulate with
care.
9.9
Position range in front of the cabinet opening.
9.10
Make sure that the cooktop which overhangs the
countertop clears the countertop. If necessary,
raise the unit by lowering the leveling legs.
9.11
Slide the range into the cutout opening and
center it before leveling it.
9.12
Level the range (see section 10). The oor
where the range is to be installed must be level.
Follow the instructions under "Leveling the
Range- Models Equipped with Leveling Device".
9.13
Adjust leveling legs so that the underside of the
cooktop is sitting on the countertop. Carefully
screw in (refer to Leveling the range: "Models
equipped with Leveling Device") the back leveling
leg until the cooktop overhang touches slightly
the countertop. Then carefully screw in the front
two leveling legs until the cooktop overhang
touches slightly the countertop.
For models equipped with Leveling Leg
only (no leveling device):
9.5
Make sure the four leveling legs (front and rear)
are setup higher than the height of the cabinet
(shown on page 3).
9.6
Install the anti-tip bracket at
this point before placing the range at its nal
position. Follow the installation instructions on
page 9 or 10 or on the anti-tip bracket template
supplied with the range.
9.7
To provide an optimum installation, the top
surface of the countertop must be level and
at (lie on the same plane) around the 3 sides
that are adjacent to range cooktop. Proper
adjustments to make the top at should be made
or gaps between the countertop and the range
cooktop may occur.
9.8
To reduce the risk of damaging
your appliance, do not handle or manipulate it by
the cooktop. Manipulate with care.
9.9
Position range in front of the cabinet opening.
9.10
Make sure that the cooktop which overhangs the
countertop clears the countertop. If necessary,
raise the unit by lowering the leveling legs.
9.11
Level the range (see section 10). The oor
where the range is to be installed must be level.
Follow the instructions under "Leveling the
Range-Models Equipped with Leveling Legs".
9.12
Slide the range into the cutout opening.
Figure 13
IMPORTANT
If Accessories Needed
Installation With Backguard
A backguard kit can be ordered through a Sears
Service Center. The cutout depth (21¾" (55,2 cm)
Min., 22
1
/
8
" (56,2 cm) Max.) needs to be increased to
24" (61 cm) when installing a backguard
Installation With End Panel
An end panel kit can be ordered through a Sears
Service Center.
Installation With Side Panel
A side panels kit can be ordered through a Sears
Service Center. Install cabinet doors 31" (78,7 cm) min.
apart so as not to interfere with range door opening.
Loading ...
Loading ...
Loading ...